having this new selector on the left column makes it a better fit for
both possible edit situations, rootfs is now fully balanced and both
mp/rootfs kip the "skip replication" setting on the same place - in
sync with VMs
Signed-off-by: Thomas Lamprecht <t.lamprecht@proxmox.com>
This allows the following non-problematic mount options for lxc
container mountpoints:
* noexec - Do not permit execution of binaries on the mounted FS
* noatime - Do not update inode access times on this filesystem
* nosuid - Do not allow suid or sgid bits to take effect
* nodev - Do not interpret character or block devices on the FS
Signed-off-by: Oguz Bektas <o.bektas@proxmox.com>
in nautilus there is no ceph-disk anymore and osd activation
does not use udev anymore so this service is not needed anymore
remove it and do not copy it when installing a new ceph cluster
in pve-storage.target we replace ceph.service with ceph.target
Signed-off-by: Dominik Csapak <d.csapak@proxmox.com>
sometimes a monitor id is only mentioned in a later part of the message
not always the first
for example, if more than one monitor is missing the msgr2 protocol
each monitor gets its own line
before this patch the whole error would only be attributed to the first
monitor mentioned, now it is attributed to all
Signed-off-by: Dominik Csapak <d.csapak@proxmox.com>
handle expected votes set to non-standard value, and try to adjust
calculations for qdevice setups.
Signed-off-by: Fabian Grünbichler <f.gruenbichler@proxmox.com>
having ipv6 enabled while not disabling ipv4 prevents
nautilus osds to start if no ipv4 network is given (because they
are trying to bind to both ip families and die if one of them
is not found)
Signed-off-by: Dominik Csapak <d.csapak@proxmox.com>
this already works on luminous, so it does not harm to add it already,
and is recommended when both msgr1 and msgr2 is activated in nautilus
Signed-off-by: Dominik Csapak <d.csapak@proxmox.com>
this fixes an issue where only one monitor is in mon_host, which is
offline, prevents a client connection
Signed-off-by: Dominik Csapak <d.csapak@proxmox.com>
we map '$type addr' to '$type_addr' anyway in the ceph.conf parser,
so this is not necessary
also use 'public_addr' if it is set
Signed-off-by: Dominik Csapak <d.csapak@proxmox.com>
mainly because it looks strange to get a warning after the upgrade is
finished and noout has been removed again
Signed-off-by: Fabian Grünbichler <f.gruenbichler@proxmox.com>
do not suggest that we ever supported it as first class storage, it
was always just a experimental support and upstream is
EOL/unmaintained now.
Signed-off-by: Thomas Lamprecht <t.lamprecht@proxmox.com>
if auth is 'none' there is no client keyring, so do not generate it and
do not write it into the config
Signed-off-by: Dominik Csapak <d.csapak@proxmox.com>
