This patch drops the redundant description of some of ip's options in
ip-link.8's description of the 'show' subcommand, preserving the
description of -iec (but appending it to the list in ip.8 with minor
fixes).
Signed-off-by: Phil Sutter <phil@nwl.cc>
Follow-up for kernel commit 8eb3b99554b8 ("geneve: support setting
IPv6 flow label") to allow setting the label for the device config.
Signed-off-by: Daniel Borkmann <daniel@iogearbox.net>
Follow-up for kernel commit e7f70af111f0 ("vxlan: support setting
IPv6 flow label") to allow setting the label for the device config.
Signed-off-by: Daniel Borkmann <daniel@iogearbox.net>
This should be made generic and part of a common tc-actions man page.
Though leave it here for now to not confuse readers of the example which
uses it.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Signed-off-by: Stephen Hemminger <stephen@networkplumber.org>
As Jamal pointed out, there are two different approaches to bandwidth
measurement. Try to make this clear by separating them in synopsis and
also documenting the way to fine-tune avrate.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Signed-off-by: Stephen Hemminger <stephen@networkplumber.org>
As Jamal suggested, BRANCH is the wrong name, as these keywords go
beyond simple branch control - e.g. loops are possible, too. Therefore
rename the non-terminal to CONTROL instead which should be more
appropriate.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Signed-off-by: Stephen Hemminger <stephen@networkplumber.org>
Recently a new temp router port mode was added and with it the dumped
information was extended similar to how mdb entries were done. This
patch adds support to dump the new information by using the "-s" switch.
Example:
$ bridge -d -s mdb show
dev br0 port eth1 grp ff02::1:ffbf:5716 temp 234.39
dev br0 port eth1 grp 239.0.0.2 temp 97.17
dev br0 port eth1 grp 239.0.0.3 temp 105.36
router ports on br0: eth1 0.00 permanent
router ports on br0: eth2 254.87 temp
It also updates the bridge man page.
Signed-off-by: Nikolay Aleksandrov <nikolay@cumulusnetworks.com>
Not sure how useful they are in practice, but as 'ip neigh' supports
setting them all, they deserve to be described as well.
While at it, also add a missing layer of indentation to the subordinate
nud state list.
Signed-off-by: Phil Sutter <phil@nwl.cc>
The documentation is wrong here: it is indeed possible to remove policy
rule 0 and recreate it afterwards. Therefore remove these statements.
Signed-off-by: Phil Sutter <phil@nwl.cc>
While the synopsis section contains 'ip route list', it is later
described as 'ip route show'. Make this consistent by replacing 'list'
with 'show' in synopsis.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Listing generic 'ip' options in subcommand man pages is redundant and
error-prone, as they won't be kept in sync anyway. Since many other man
pages don't list them either, drop references to them in the remaining
ones.
Signed-off-by: Phil Sutter <phil@nwl.cc>
The 'ADDR' part of 'local' and 'remote' parameters is not optional, but
may also consist of the word 'any'. While at it, add missing whitespace
and fix fonts.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Drop unnecessary curly braces around single action keywords, point out
that 'dev' parameter to 'ip token get' is optional and clarify that 'ip
token' defaults to 'list' action.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Clarify that 'ip rule' defaults to action 'list', that 'flush' and
'save' actions don't accept additional parameters, add missing 'not' and
'goto' keywords and finally fix fonts used in 'fwmark' and 'realms'
parameters.
Signed-off-by: Phil Sutter <phil@nwl.cc>
The first line contained a c'n'p error, incorrectly listing 'ip address'
syntax. Since PARAMS is used just once and there are not many other
parameters to 'ip ntable change', state them inline and in addition to
that clarify the possibility to pass multiple parameters at once.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Use brackets to show that 'ip netns' defaults to action 'list', drop
superfluous curly braces around 'set' action keyword.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Reflect that it is possible to pass multiple parameters at the same
time, also use the same trick the help text uses to emphasize vf
specific parameters.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Clarify that the optional '-' prefix of the 'tentative', 'deprecated'
and 'dadfailed' keywords has to be put right in front of them, no
whitespace is allowed in between.
In addition to that, clarify that it is valid to pass both 'valid_lft'
and 'preferred_lft' at the same time to 'ip address'.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Recently support was added to the kernel to be able to add more per-mdb
entry attributes via standard netlink attributes of type MDBA_MDB_EATTR_.
This patch adds support to iproute2 to parse and output these
attributes. The first exported attribute is the mdb "timer" value which
is shown only when the "-s" iproute2 arg is used.
Example:
$ bridge -s mdb show
dev br0 port eth1 grp 239.0.0.11 permanent 0.00
dev br0 port eth1 grp 239.0.0.10 temp 244.15
dev br0 port eth1 grp 239.0.0.1 temp 245.21
dev br0 port eth1 grp 239.0.0.5 temp 246.43
dev br0 port eth2 grp 239.0.0.5 temp 248.44
dev br0 port eth1 grp 239.0.0.2 temp 245.32
Signed-off-by: Nikolay Aleksandrov <nikolay@cumulusnetworks.com>
Add IFLA_VF_TRUST message to trust the VF.
PF can accept some privileged operation from the trusted VF.
For example, ixgbe PF doesn't allow to enable VF promiscuous mode until
the VF is trusted because it may hurt performance.
To trust VF.
# ip link set dev eth0 vf 1 trust on
To untrust VF.
# ip link set dev eth0 vf 1 trust off
Signed-off-by: Hiroshi Shimamoto <h-shimamoto@ct.jp.nec.com>
This patch is a follow up to the recently added
'static' fdb option.
It introduces a new option 'dynamic' which adds
dynamic fdb entries with NUD_REACHABLE.
$bridge fdb add 00:01:02:03:04:06 dev eth0 master dynamic
$bridge fdb show
00:01:02:03:04:06 dev eth0
This patch also documents all fdb types. Removes 'temp'
from usage message since it is now replaced by 'static'.
'temp' still works and is synonymous with static.
Signed-off-by: Wilson Kok <wkok@cumulusnetworks.com>
Signed-off-by: Roopa Prabhu <roopa@cumulusnetworks.com>
This patch adds a -K / --kill option to ss that attempts to
forcibly close matching sockets using SOCK_DESTROY.
Because ss typically prints sockets instead of acting on them,
and because the kernel only supports forcibly closing some types
of sockets, the output of -K is as follows:
- If closing the socket succeeds, the socket is printed.
- If the kernel does not support forcibly closing this type of
socket (e.g., if it's a UDP socket, or a TIME_WAIT socket),
the socket is silently skipped.
- If an error occurs (e.g., permission denied), the error is
reported and ss exits.
Signed-off-by: Lorenzo Colitti <lorenzo@google.com>
grff wrapper returns warnings when parsing the ip-link.8.in file.
How to reproduce:
$ man --warnings ip-link > /dev/null
`R' is a string (producing the registered sign), not a macro.
[...]
Signed-off-by: Thomas Faivre <thomas.faivre@6wind.com>
Signed-off-by: Nicolas Dichtel <nicolas.dichtel@6wind.com>
Options 'group' and 'remote' cannot take 'any' as value but 'local' can.
Signed-off-by: Thomas Faivre <thomas.faivre@6wind.com>
Signed-off-by: Nicolas Dichtel <nicolas.dichtel@6wind.com>
This enables a user to remove an offline peer from the kernel data
structures. This could for example be useful when deliberately scaling
in peer nodes in a cloud environment.
Signed-off-by: Richard Alpe <richard.alpe@ericsson.com>
Reviewed-by: Jon Maloy <jon.maloy@ericsson.com>
Reviewed-by: Ying Xue <ying.xue@windriver.com>
This enables a user to remove an offline peer from the kernel data
structures. This could for example be useful when deliberately scaling
in peer nodes in a cloud environment.
Signed-off-by: Richard Alpe <richard.alpe@ericsson.com>
Reviewed-by: Jon Maloy <jon.maloy@ericsson.com>
Reviewed-by: Ying Xue <ying.xue@windriver.com>
Despite commit 45a82e5 ("iproute vxlan add support for fdb replace
command"), the 'fdb replace' command was not mentioned in bridge.8.
Signed-off-by: Phil Sutter <phil@nwl.cc>
This patch adds save and restore commands to "ip rule"
similar the same is made in commit f4ff11e3e2 for "ip route".
The feature is useful in checkpoint/restore for container
migration, also it may be helpful in some normal situations.
Signed-off-by: Kirill Tkhai <ktkhai@odin.com>
This has been inconsistent since the beginning of Git and seems to be
merely a documentation leftover, therefore just remove it from help
output and man page.
Signed-off-by: Phil Sutter <phil@nwl.cc>
This patch updates ip-route man page with lwtunnel encap
usage and description, covering MPLS and IP encapsulation.
Signed-off-by: Roopa Prabhu <roopa@cumulusnetworks.com>
Signed-off-by: Thomas Graf <tgraf@suug.ch>
Acked-by: Jiri Benc <jbenc@redhat.com>
This patch adds support to batch bridge commands.
Follows ip batch code.
Signed-off-by: Wilson Kok <wkok@cumulusnetworks.com>
Signed-off-by: Roopa Prabhu <roopa@cumulusnetworks.com>
Acked-by: Christophe Gouault <christophe.gouault@6wind.com>
This patch adds man pages for the TIPC tool. There is one main page
and one page for each top level sub-command. These pages mainly aims
to help a user of the tipc tool. In addition to this they describe
a bit about what TIPC is and some of its features as a protocol.
Signed-off-by: Richard Alpe <richard.alpe@ericsson.com>
Reviewed-by: Erik Hugne <erik.hugne@ericsson.com>
Reviewed-by: Jon Maloy <jon.maloy@ericsson.com>
Partially based on kernel Kconfig help text, code comments and
git commit messages from Eric Dumazet.
Joint work with Phil Sutter.
Signed-off-by: Phil Sutter <phil@nwl.cc>
Signed-off-by: Florian Westphal <fw@strlen.de>
Some qdiscs still lack a manpage, so listing them here is the only way
for a user to get to know them. For the others, this serves as an
overview of what is there.
Content was taken over from the dedicated manpage if available and
suitable, so there is definitely room for improvement at least by
adjusting it more to the context in which it is now. In case there
wasn't appropriate wording available, I tried to identify key aspects of
the given qdisc.
Signed-off-by: Phil Sutter <phil@nwl.cc>
