Comparison of the two pointer is confusing, they have no relevance
except the time both of them are empty.
Additionly modify one variable name and correct some comment words, they
are same in both ospfd and ospf6d.
Signed-off-by: anlan_cs <anlan_cs@tom.com>
Added the High Level design for implementing MLD and PIMv6.
Added a PPT as well in case someone wants to translate it
to some other language.
Signed-off-by: Mobashshera Rasool <mrasool@vmware.com>
Description:
Change is intended for fixing the issue related to
clearing of stale leaked routes:
- Whenever BGP goes down,
after bringing down tcp connection and renegotiating capabilities,
once we reestablish connection,
we are not handling clear of VRF leaked route in the bgp_clear_stale_route.
- While bgp is clearing stale routes,
we need to handle withdraw of routes for VRF route-leaking.
Co-authored-by: Kantesh Mundaragi <kmundaragi@vmware.com>
Signed-off-by: Iqra Siddiqui <imujeebsiddi@vmware.com>
The zlog_warn used to be bounded by a debug guard
but the debug guard was removed but the code was
never fixed up to remove the open and close paranthesis.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
Extended BGP Administrative Shutdown Communication (rfc9003):
Basically, shutdown message size is increased to 255 from 128.
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
The test is doing this:
a) gather interface data about packets sent
b) shut interface
c) no shut interface
d) gather interface data about packets sent
e) compare a to d and fail if packets sent/received has not incremented
The problem is, of course, that under heavy system load insufficient time
might not have passed for packets to be sent between c and d. Add up to
35 seconds of looking for packet data being incremented else heavily
loaded systems may never show that data is being sent.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
verify_pim_interface_traffic *fetches* the pim
traffic data. Rename the function to what it
actually does
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
On lower CPU with lots of static routes, it will cost more than 2
minutes.
2 minutes is the default timeout value, we can adjust it by configure:
./configure --with-service-timeout=<digit>
Signed-off-by: anlan_cs <anlan_cs@tom.com>
The nhrp_topo test sets up some infrastructure and
was displaying the commands it was outputting
incorrectly. Fix this.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
Using with LLGR, this should be allowed setting GR restart-time timer to 0,
to immediately start LLGR timers.
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
rfc7196 recommends:
In addition, BGP implementations have an internal constant, which we
will call the 'maximum penalty', and the current computed penalty may
not exceed it.
Router Maximum Penalty: The internal constant for the maximum
penalty value MUST be raised to at least 50,000.
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
The following subcodes are defined for the Cease NOTIFICATION
message:
Subcode Symbolic Name
1 Maximum Number of Prefixes Reached
2 Administrative Shutdown
3 Peer De-configured
4 Administrative Reset
5 Connection Rejected
6 Other Configuration Change
7 Connection Collision Resolution
8 Out of Resources
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
