Previously we just raised an error for the test file with possibly all tests
passing. Now we fail any test that produces new backtraces or cores. This
just works a lot better with analysis and even CI.
Also be less verbose to the console after failure runs, just show error
level and above logs. The log files still capture all levels (DEBUG).
Signed-off-by: Christian Hopps <chopps@labn.net>
Currently, "on-match (next|goto)" only works if already present in a
route-map entry when the route-map is applied to the routes. However, if
the command is added to an existing route-map entry, the route-map is
not reapplied to the routes in order to accommodate the changes. And
service restart is needed. The problem is that setting the command
doesn't signal about the change to the listener (i.e. to a routing
daemon).
With this fix, signal to the listener about addition of "on-match
(next|goto)" to a route-map entry.
Signed-off-by: Alexander Chernavin <achernavin@netgate.com>
`bnc->ifindex` should not be with 0 ( IFINDEX_INTERNAL ), so we can ignore
the wrong interface to make it safe.
Signed-off-by: anlan_cs <vic.lan@pica8.com>
Currently the vrf change procedure for the deleted interface is after
its deletion, it causes problem for upper daemons.
Here is the problem of `bgp`:
After deletion of one **irrelevant** interface in the same vrf, its
`ifindex` is set to 0. And then, the vrf change procedure will send
"ZEBRA_INTERFACE_DOWN" to `bgpd`.
Normally, `bgp_nht_ifp_table_handle()` should igore this message for
no correlation. However, it wrongly matched `ifindex` of 0, and removed
the related routes for the down `bnc`.
Adjust the location of the vrf change procedure to fix this issue.
Signed-off-by: anlan_cs <vic.lan@pica8.com>
Make the ospf6_lsa_unlock take the same parameters
that the ospf_lsa_unlock does to make it consistent
and to also ensure that no-one can make the mistake
of getting the pointer cleared up.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
Adjust one debug info, separate the ip address from it. Just like it is processed
in `redistribute_update()`.
Before:
```
34:1375.75.75.75/32: Redist del: re 0x55c1112067e0 (0:static), new re 0x55c1112de7c0 (0:static)
```
After:
```
(34:13):75.75.75.75/32: Redist del: re 0x55c1112067e0 (0:static), new re 0x55c1112de7c0 (0:static)
```
Signed-off-by: anlan_cs <vic.lan@pica8.com>
Add a test-case to the NHRP test that installs routes over the
NHRP tunnel endpoint routes. This confirms that zebra will use
NHRP routes when validating incoming routes from other daemons
(sharpd in this test).
Signed-off-by: Mark Stapp <mjs@labn.net>
Add a config option so that sharpd can install routes without
the ALLOW_RECURSION flag, matching IGP behavior.
The default remains 'recursion'.
Signed-off-by: Mark Stapp <mjs@labn.net>
Treat NHRP-installed routes as valid, as if they were
CONNECTED routes, when checking candidate routes'
nexthops for validity. This allows use of NHRP by an
IGP, for example, that doesn't normally want recursive
nexthop resolution.
Signed-off-by: Mark Stapp <mjs@labn.net>
bgp_zebra_tm_connect calls bgp_zebra_get_table_range which
just used the global zclient. Which of course still had
us exposing the global zclient to read and drop important
data from zebra. This fixes commit 787c61e03c
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
bgp_zebra_tm_connect calls bgp_zebra_get_table_range which
just used the global zclient. Which of course still had
us exposing the global zclient to read and drop important
data from zebra. This fixes commit 787c61e03c
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
The changes allow the test to correctly pass in case the connection
between two peers is be established in less than 0.5 seconds after the
delayopen timer expires.
Signed-off-by: David Schweizer <dschweizer@opensourcerouting.org>
Code is looking up the nlsock to generate the batch messages
and then looking it up again to get the response. Let's
just look it up one time.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
