Problem reported that when "systemctl restart networking" was
performed, prefixes previously redistributed into bgp from connected
were deleted from the bgp table. Determined that we were not correctly
changing the redistribution bitmask when the vrf_id of the vrf was
changed. This patch corrects that behavior.
Manual tests look good. bgp-min and vrf-min completed with no new failures.
Ticket: CM-19369
Signed-off-by: Don Slice <dslice@cumulusnetworks.com>
Reviewed-by: Donald Sharp <sharpd@cumulusnetworks.com>
The 'ip pim use-source ...' command returns a hard
success/failure. Allow it to return a soft-failure
for when we re-enter the same line.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
The BGP IO thread must be running before other threads
can start using it. So at startup check to see
that it running once, instead of before every
function call into.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
-Werror=sign-compare is failing with signed/unsigned usage
in the conditional expression.
Fixes: #1593
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
When PIM handles some MSDP commands, a repeated command
was causing a CMD_WARNING_CONFIG_FAILED. This should
be a CMD_WARNING. Fix the code to allow vtysh to handle
this appropriately.
Ticket: CM-19053
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
The rn can not have an rn->info pointer and as
such the dest may be NULL. Don't assign
the old_fib pointer if so. This is ok
because we know RNODE_FOREACH... will not
iterate if dest is NULL.
Fixes: #1575
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
When ospf6 configure with redistribute connected/protocol
with route-map. Upon restart of frr.service, ospf6 receives
redistribute update then route-map update.
During redistribute route update, since route-map info is not
filled, route is suppressed from injected as external route.
Fix: reset redistribute when route-map update received
matches with redistribution (type) and route-map name.
Ticket:CM-13800
Testing Done:
Configure ospf6 redistribute with route-map to inject
Type-2 external routes into database. Trigger frr restart
redistribute with route-map happens.
Signed-off-by: Chirag Shah <chirag@cumulusnetworks.com>
Peek functionality for ring buffers and associated tests.
Also:
* Slight optimization to avoid 0-byte memcpy() by changing > to >=
* Add rv checks for some ringbuf_[put|get] calls that were missing them
in the test
Signed-off-by: Quentin Young <qlyoung@cumulusnetworks.com>
Problems reported with inconsistent use of parameters for bgp network
statements. Converted 12 DEFUNs to 2 DEFPY statements, making the
parameter use consistent with the exception of keeping the "backdoor"
keywork ipv4 only. Also verified that if a route-map or label-index
is specified in the "no" case it matches what had been previously
defined. Manual testing looks good and bgp-smoke will be performed
before pushing.
Ticket: CM-16860
Signed-off-by: Don Slice <dslice@cumulusnetworks.com>
Reviewed-by: CCR-7056
The json code was freeing json_paths and then
turning around and free'ing it again. Newer
versions of json-c have started to assert
this bad behavior.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
- used @sharpd's slack patch as a starting point
- fixes compile time issue, but code path not tested
Signed-off-by: Raymond P. Burkholder <github@oneunified.net>
This reverts commit d9e5b00955.
ETH_ALEN is not equivalent to ETHER_HDR_LEN. ETHER_HDR_LEN is the
definition for the length of the full ethernet header, meanwhile
ETH_ALEN is just the length of the ethernet address.
Here is the OpenBSD/FreeBSD definition for ETHER_HDR_LEN:
#define ETHER_ADDR_LEN 6 /* Ethernet address length */
#define ETHER_TYPE_LEN 2 /* Ethernet type field length */
#define ETHER_HDR_LEN ((ETHER_ADDR_LEN * 2) + ETHER_TYPE_LEN)
(OpenBSD's definition is at net/if_ether.h, FreeBSD's is at
net/ethernet.h)
Linux definitions can be found at: net/ethernet.h
#define ETHER_ADDR_LEN ETH_ALEN /* size of ethernet addr */
#define ETHER_TYPE_LEN 2 /* bytes in type field */
#define ETHER_HDR_LEN ETH_HLEN /* total octets in header */
net/if_ether.h:
#define ETH_HLEN 14 /* Total octets in header. */
#define ETH_ALEN 6 /* Octets in one ethernet addr */
Signed-off-by: Rafael Zalamena <rzalamena@opensourcerouting.org>
