mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/chenhuacai/linux-loongson
synced 2025-08-27 06:50:37 +00:00
75a71ecc24
Enumerate all available DPLL channels and registers a DPLL device for each of them. Check all input references and outputs and register DPLL pins for them. Number of registered DPLL pins depends on configuration of references and outputs. If the reference or output is configured as differential one then only one DPLL pin is registered. Both references and outputs can be also disabled from firmware configuration and in this case no DPLL pins are registered. All registrable references are registered to all available DPLL devices with exception of DPLLs that are configured in NCO (numerically controlled oscillator) mode. In this mode DPLL channel acts as PHC and cannot be locked to any reference. Device outputs are connected to one of synthesizers and each synthesizer is driven by some DPLL channel. So output pins belonging to given output are registered to DPLL device that drives associated synthesizer. Finally add kworker task to monitor async changes on all DPLL channels and input pins and to notify about them DPLL core. Output pins are not monitored as their parameters are not changed asynchronously by the device. Co-developed-by: Prathosh Satish <Prathosh.Satish@microchip.com> Signed-off-by: Prathosh Satish <Prathosh.Satish@microchip.com> Signed-off-by: Ivan Vecera <ivecera@redhat.com> Reviewed-by: Jiri Pirko <jiri@nvidia.com> Link: https://patch.msgid.link/20250704182202.1641943-9-ivecera@redhat.com Signed-off-by: Jakub Kicinski <kuba@kernel.org>
11 lines
263 B
Makefile
11 lines
263 B
Makefile
# SPDX-License-Identifier: GPL-2.0
|
|
|
|
obj-$(CONFIG_ZL3073X) += zl3073x.o
|
|
zl3073x-objs := core.o devlink.o dpll.o prop.o
|
|
|
|
obj-$(CONFIG_ZL3073X_I2C) += zl3073x_i2c.o
|
|
zl3073x_i2c-objs := i2c.o
|
|
|
|
obj-$(CONFIG_ZL3073X_SPI) += zl3073x_spi.o
|
|
zl3073x_spi-objs := spi.o
|