From ca47e9efe1d3267bff58cb1d4c44e9b94cfc197e Mon Sep 17 00:00:00 2001 From: Christoph Heiss Date: Fri, 23 Feb 2024 12:48:47 +0100 Subject: [PATCH] installation: convert installer screenshots to thumbnails Again, like the PVE documantation. Improves the reading flow quite a bit too. Signed-off-by: Christoph Heiss --- pmg-installation.adoc | 17 +++++++++-------- 1 file changed, 9 insertions(+), 8 deletions(-) diff --git a/pmg-installation.adoc b/pmg-installation.adoc index 8833b41..128c494 100644 --- a/pmg-installation.adoc +++ b/pmg-installation.adoc @@ -48,11 +48,11 @@ TIP: Make sure that booting from the installation medium (for example, USB) is enabled in your server's firmware settings. Secure boot needs to be disabled when booting an installer prior to {pmg} version 8.1. +[thumbnail="../installer/pmg-grub-menu.png"] + After choosing the correct entry (for example, Boot from USB) the {pmg} menu will be displayed, and one of the following options can be selected: -image::images/installer/pmg-grub-menu.png[] - Install {pmg} (Graphical):: Start normal installation. @@ -113,7 +113,8 @@ of errors. Secure Boot must be turned off in the UEFI firmware setup utility to run this option. You normally select *Install {pmg} (Graphical)* to start the installation. -image::images/installer/pmg-select-target-disk.png[] + +[thumbnail="../installer/pmg-select-target-disk.png"] The first step is to read our EULA (End User License Agreement). Following this, you can select the target hard disk(s) for the installation. @@ -135,7 +136,7 @@ lets you choose the ZFS RAID level and select which disks will be used. WARNING: ZFS on top of any hardware RAID is not supported and can result in data loss. -image::images/installer/pmg-select-location.png[] +[thumbnail="../installer/pmg-select-location.png", float="left"] The next page asks for basic configuration options like your location, timezone, and keyboard layout. The location is used to @@ -144,7 +145,7 @@ The installer is usually able to auto-detect these settings, so you only need to change them in rare situations when auto-detection fails, or when you want to use a keyboard layout not commonly used in your country. -image::images/installer/pmg-set-password.png[] +[thumbnail="../installer/pmg-set-password.png"] You then need to specify an email address and the superuser (root) password. The password must have at least 5 characters, but we highly @@ -168,13 +169,13 @@ example: All those notification mails will be sent to the specified email address. -image::images/installer/pmg-setup-network.png[] +[thumbnail="../installer/pmg-setup-network.png"] The next step is the network configuration. Please note that you can use either IPv4 or IPv6 here, but not both. If you want to configure a dual stack node, you can easily do that after the installation. -image::images/installer/pmg-summary.png[] +[thumbnail="../installer/pmg-installation.png", float="left"] When you press `Next`, you will see an overview of your entered configuration. Please re-check every setting, you can still use the `Previous` button to go @@ -183,7 +184,7 @@ back and edit any settings. After clicking `Install`, the installer will begin to format and copy packages to the target disk(s). -image::images/installer/pmg-installation.png[] +[thumbnail="../installer/pmg-summary.png"] Copying the packages usually takes several minutes. When this is finished, you can reboot the server.