mirror of
https://git.proxmox.com/git/mirror_ubuntu-kernels.git
synced 2026-01-06 18:47:33 +00:00
4af81f02b4
- Store the previous and current rate set in the driver + the TSF value at the time of the switch. - Use the tx status TSF value to determine which rate set needs to be used as reference. - Report only short or long GI rates for a single status event, not a mix. - The hardware reports the last used rate index. Use it along with the retry count to figure out what rate was used for the first attempt. - Use the same retry count value for all rate slots to make this calculation work. - Derive the probe rate from the current rateset instead of the skb cb - Do not wait for a status report for the probe frame before removing the probe rate from the rate table. Do it immediately after it was referenced in a tx status report. - Use the first half of the first rate retry budget for the probe rate in order to avoid using too many retries on that rate - Switch from lower rates to higher rates more conservatively - enable hardware rate up/down selection Reviewed-by: Ryder Lee <ryder.lee@mediatek.com> Signed-off-by: Felix Fietkau <nbd@nbd.name> |
||
|---|---|---|
| .. | ||
| admtek | ||
| ath | ||
| atmel | ||
| broadcom | ||
| cisco | ||
| intel | ||
| intersil | ||
| marvell | ||
| mediatek | ||
| quantenna | ||
| ralink | ||
| realtek | ||
| rsi | ||
| st | ||
| ti | ||
| zydas | ||
| Kconfig | ||
| mac80211_hwsim.c | ||
| mac80211_hwsim.h | ||
| Makefile | ||
| ray_cs.c | ||
| ray_cs.h | ||
| rayctl.h | ||
| rndis_wlan.c | ||
| virt_wifi.c | ||
| wl3501_cs.c | ||
| wl3501.h | ||