ACP pin configuration varies based on acp version.
ACP PCI driver should read the ACP PIN config value and based on config
value, it has to create a platform device in below two conditions.
1) If ACP PDM configuration is selected from BIOS and ACP PDM controller
exists.
2) If ACP I2S configuration is selected from BIOS.
Other than above scenarios, ACP PCI driver should skip the platform
device creation logic, i.e. ACP PCI driver probe sequence should never
fail if other acp pin configuration is selected. It should skip platform
device creation logic.
check_acp_pdm() function was implemented for ACP6.x platforms to check
ACP PDM configuration. Previously, this code was safe guarded by
FLAG_AMD_LEGACY_ONLY_DMIC flag check.
This implementation breaks audio use cases for Huawei Matebooks which are
based on ACP3.x varaint uses I2S configuration.
In current scenario, check_acp_pdm() function returns -ENODEV value
which results in ACP PCI driver probe failure without creating a platform
device even in case of valid ACP pin configuration.
Implement check_acp_config() as a common function which invokes platform
specific acp pin configuration check functions for ACP3.x, ACP6.0 & ACP6.3
& ACP7.0 variants and checks for ACP PDM controller.
Closes: https://bugzilla.kernel.org/show_bug.cgi?id=218780
Fixes: 4af565de9f ("ASoC: amd: acp: fix for acp pdm configuration check")
Signed-off-by: Vijendar Mukunda <Vijendar.Mukunda@amd.com>
Link: https://lore.kernel.org/r/20240502140340.4049021-1-Vijendar.Mukunda@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
acp-deinit function will not be same for all platforms.
To make platform specific changes in acp-deinit
function, instead of passing base address pass chip
structure which contains acp_rev feild.
chip->acp_rev will be used to add platform specific code
in acp-deinit().
Signed-off-by: Syed Saba Kareem <Syed.SabaKareem@amd.com>
Link: https://lore.kernel.org/r/20231021145110.478744-10-Syed.SabaKareem@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
add name of the platform and flag data in private data structure.
name of the platform will be used to differentiate platforms where as
flag will be used to know what kind of endpoint configuration is selected
where its legacy(I2S + PDM) or only ACP PDM.
Signed-off-by: Syed Saba Kareem <Syed.SabaKareem@amd.com>
Link: https://lore.kernel.org/r/20231021145110.478744-7-Syed.SabaKareem@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Store the 'xfer_resolution' of the stream in private data structure,
it will be used to reprogram the xfer_resolution for the active stream
during system level resume.
Signed-off-by: Syed Saba Kareem <Syed.SabaKareem@amd.com>
Link: https://lore.kernel.org/r/20230626135515.1252063-7-Syed.SabaKareem@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Store the platform device reference created in pci driver,
it will be used in restoring the interrupts during system level resume.
Signed-off-by: Syed Saba Kareem <Syed.SabaKareem@amd.com>
Link: https://lore.kernel.org/r/20230626135515.1252063-5-Syed.SabaKareem@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Instead of having individual acp enable/disable interrupts functions for
each platform, implement common place holder to handle the same for all
AMD platforms.
Signed-off-by: Syed Saba Kareem <Syed.SabaKareem@amd.com>
Link: https://lore.kernel.org/r/20230626135515.1252063-4-Syed.SabaKareem@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Add acp i2s master clock generation logic for rembrandt platform.
Signed-off-by: V Sujith Kumar Reddy <vsujithkumar.reddy@amd.com>
Signed-off-by: Syed Saba Kareem <Syed.SabaKareem@amd.com>
Link: https://lore.kernel.org/r/20230626135515.1252063-3-Syed.SabaKareem@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Remove the individual acp init and de-init functions from different
variants of acp pci driver(for renoir/rembrandt platforms) and use a
common file to define callbacks and refactor the callbacks to support
existing platforms.
Signed-off-by: Syed Saba Kareem <Syed.SabaKareem@amd.com>
Link: https://lore.kernel.org/r/20230626135515.1252063-2-Syed.SabaKareem@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
For invalid dai id, instead of returning -EINVAL
return bytes count as zero in acp_get_byte_count() function.
Fixes: 623621a9f9 ("ASoC: amd: Add common framework to support I2S on ACP SOC")
Signed-off-by: Vijendar Mukunda <Vijendar.Mukunda@amd.com>
Link: https://lore.kernel.org/r/20230626105356.2580125-6-Vijendar.Mukunda@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Add callback and code changes to enable ACP I2S controller in TDM
mode. Add new fields in acp_stream and acp_dev_data struct to configure
tdm related registers for ACP i2s controllers.
Signed-off-by: Venkata Prasad Potturu <venkataprasad.potturu@amd.com>
Link: https://lore.kernel.org/r/20220810132913.1181247-3-venkataprasad.potturu@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
We are currently allocating acp_stream during pcm_open and saving
it in static array corresponds to array index calculated based on
cpu dai->driver id. This approach will fail if we have single dai
linked to multiple pcm device as we will have same dai->driver id
or array index for multiple pcm open. Initialize new linked list
stream_list to store opened pcm stream info dynamically.
Signed-off-by: Ajit Kumar Pandey <AjitKumar.Pandey@amd.com>
Signed-off-by: Venkata Prasad Potturu <venkataprasad.potturu@amd.com>
Reviewed-by: Vijendar Mukunda <Vijendar.Mukunda@amd.com>
Link: https://lore.kernel.org/r/20220810132913.1181247-2-venkataprasad.potturu@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Add i2s and dmic support for Rembrandt platform,
Add machine support for nau8825, max98360 and rt5682s,rt1019 codec
in legacy driver for rembrandt platform.
Here codec is in a slave mode.
Signed-off-by: V sujith kumar Reddy <Vsujithkumar.Reddy@amd.com>
Link: https://lore.kernel.org/r/20220707161142.491034-4-Vsujithkumar.Reddy@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
ADD Generic code to support to newer platforms, add
control threshold, irq control macros ,added structure for register
offset differences.
Signed-off-by: V sujith kumar Reddy <Vsujithkumar.Reddy@amd.com>
Link: https://lore.kernel.org/r/20220707161142.491034-3-Vsujithkumar.Reddy@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Audio Co-processor or ACP IP block on AMD's SOC is connected via
PCI bus interface, hence needs to be register as a PCI device. We
have same PCI device ID across multiple SOC's but with different
revision id for PCI hw. Add a generic PCI driver module for ACP
that registers ACP as a PCI device and also register a platform
device based on pci revision id. Any SOC's specific configuration
for ACP block will be done in platform driver probe. We have added
an initial support for ACP revision id 3 or ACP3X device.
Signed-off-by: Ajit Kumar Pandey <AjitKumar.Pandey@amd.com>
Link: https://lore.kernel.org/r/20220117115854.455995-4-AjitKumar.Pandey@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Add driver module for PDM controller on ACP IP block. Expose dai
ops to configure ACP_WOV_PDM_BLOCK registers on ACP. Such dai ops
will be used by platform specific driver module to register dmic
related dai with ASoC.
Signed-off-by: Ajit Kumar Pandey <AjitKumar.Pandey@amd.com>
Link: https://lore.kernel.org/r/20220117115854.455995-2-AjitKumar.Pandey@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
We are using legacy way of exposing dais and DMA configuration that
requires separate driver modules for various ACP SOC with almost
similar hw configuration. Moreover the legacy approach requires
separate I2S and DMA module platform devices registration and need
machine specific quirk to control various I2S endpoints. Add generic
dai driver and platform driver for I2S controller on ACP hw block.
This common framework can be used by various ACP platform devices
that shares common specs.
Signed-off-by: Ajit Kumar Pandey <AjitKumar.Pandey@amd.com>
Link: https://lore.kernel.org/r/20211019070938.5076-2-AjitKumar.Pandey@amd.com
Signed-off-by: Mark Brown <broonie@kernel.org>
