This commit make bgpd to skip and ignore unsupported
sub-type of PREFIX_SID. (especially new defined sub-type)
Current bgpd can't parase unsupported sub-type of PREFIX_SID.
PREFIX_SID is drafted on draft-ietf-idr-bgp-prefix-sid-27.
There are already new sub-type drafted on
draft-dawra-idr-srv6-vpn-05. (Type5,6 is new defined.)
This commit fix the problem reported as #5277 on GitBub.
Signed-off-by: Hiroki Shirokura <slank.dev@gmail.com>
this table identifier can be used for policy routing. incoming entries
are locally exported to that local table identifier.
note that so that the user applies the new table identifier to all
entries, the user should flush local tables first.
Signed-off-by: Philippe Guibert <philippe.guibert@6wind.com>
RFC 4271 sec 6.3 p33, In the case of a BGP_NEXTHOP attribute with an
incorrect value, FRR is supposed to send a notification
and include 'Corresponding type, length and value of the NEXT_HOP
attribute in the notification data.
Fixes: #4997
Signed-off-by: Nikos <ntriantafillis@gmail.com>
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
Allow bgp to set a local Administrative distance to use
for installing routes into the rib.
Example:
!
router bgp 9323
bgp router-id 1.2.3.4
neighbor enp0s8 interface remote-as external
!
address-family ipv4 unicast
neighbor enp0s8 route-map DISTANCE in
exit-address-family
!
route-map DISTANCE permit 10
set distance 153
!
line vty
!
end
eva# show ip route
Codes: K - kernel route, C - connected, S - static, R - RIP,
O - OSPF, I - IS-IS, B - BGP, E - EIGRP, N - NHRP,
T - Table, v - VNC, V - VNC-Direct, A - Babel, D - SHARP,
F - PBR, f - OpenFabric,
> - selected route, * - FIB route, q - queued route, r - rejected route
B 0.0.0.0/0 [153/0] via fe80::a00:27ff:fe84:c2d6, enp0s8, 00:00:06
K>* 0.0.0.0/0 [0/100] via 10.0.2.2, enp0s3, 00:06:31
B>* 1.1.1.1/32 [153/0] via fe80::a00:27ff:fe84:c2d6, enp0s8, 00:00:06
B>* 1.1.1.2/32 [153/0] via fe80::a00:27ff:fe84:c2d6, enp0s8, 00:00:06
B>* 1.1.1.3/32 [153/0] via fe80::a00:27ff:fe84:c2d6, enp0s8, 00:00:06
C>* 10.0.2.0/24 is directly connected, enp0s3, 00:06:31
K>* 169.254.0.0/16 [0/1000] is directly connected, enp0s3, 00:06:31
eva#
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
This change addresses the following:
1) Ensures logs under DEBUG macro checks are categorized
as zlog_debug instead of zlog_info.
2) Error logs are categorized as zlog_err instead of zlog_info.
3) Rephrasing certain logs to make them appear more intuitive.
Signed-off-by: NaveenThanikachalam <nthanikachal@vmware.com>
Problem reported that when vrf route-leaking between an unnumbered
peer in one vrf to a numbered peer in another vrf, the nexthop
attribute was missing from the update, causing the session to fail.
determined that we needed to expand the mechanism for verifying if
the route has been learned in the other vrf without an ipv4 nexthop.
Ticket: CM-25610
Signed-off-by: Don Slice <dslice@cumulusnetworks.com>
bgp update messages were not correctly calculating the size
for a labeled-unicast prefix, as they were not accounting
for the label. If the update message was large enough to
overflow the maximum packet size (4096 bytes) this could
cause bgpd to send a malformed update packet.
Signed-off-by: Emanuele Di Pascale <emanuele@voltanet.io>
Modify the code such that we can auto turn the iana values of afi
and safi to pleasant to read strings.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
The bgp_attr_extcom_tunnel_type does not properly
compile with warnings turned on due to recent change.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
It doesn't make much sense for a hash function to modify its argument,
so const the hash input.
BGP does it in a couple places, those cast away the const. Not great but
not any worse than it was.
Signed-off-by: Quentin Young <qlyoung@cumulusnetworks.com>
This diff contains 2 parts:
1. Extract the tunnel type info from bgp extended communities.
2. Make rfapi use this common tunnel type ap
Signed-off-by: Lakshman Krishnamoorthy <lkrishnamoor@vmware.com>
This is causing interop issues with vendors. According to the RFC,
receiver should ignore the NEXT_HOP attribute with MP_REACH_NLRI
present.
Signed-off-by: nikos <ntriantafillis@gmail.com>
This is causing interop issues with vendors. According to the RFC,
receiver should ignore the NEXT_HOP attribute with MP_REACH_NLRI
present.
Signed-off-by: nikos ntriantafillis@gmail.com
When using remove-private-AS together with local-as
aspath_remove_private_asns() is called before bgp_packet_attribute().
In this case, private AS will always appear in front of change_local_as.
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
We have the same warn message in 3 spots, which makes it extremely
hard to figure out which of the 3 has gone terribly wrong.
Add a bit of code to disambiguate the 3 situations.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
Any evpn bgp update message comes with router mac extended
community, which can potentially contain the madd adddress
same as any of the local SVIs (L3VNI) MAC address.
Set route mac exist and during route processing in
bgp_update() filter the route.
Ticket:CM-23674
Reviewed By:CCR-8336
Testing Done:
Configure L3vni mac on TORS1 which is similar to TORC11
L3vni MAC. When TORC11 received the EVPN update with
Router mac extended community, this check rejected the
BGP update message.
Signed-off-by: Chirag Shah <chirag@cumulusnetworks.com>
Consider the following topo VTEP1->SPINE1->VTEP2. ebgp is being used
for evpn route exchange with SPINE just acting as a pass through.
1. VTEP1 was building the type-3 IMET route with the correct PMSI
tunnel type (ingress-replication) and label (VNI)
2. Spine1 was however only parsing the tunnel-type in the attr (was
skipping parsing of the label field altogether) -
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
root@MSP1:~# net show bgp l2vpn evpn route rd 27.0.0.15:4 type multicast
EVPN type-2 prefix: [2]:[ESI]:[EthTag]:[MAClen]:[MAC]
EVPN type-3 prefix: [3]:[EthTag]:[IPlen]:[OrigIP]
EVPN type-5 prefix: [5]:[ESI]:[EthTag]:[IPlen]:[IP]
BGP routing table entry for 27.0.0.15:4:[3]:[0]:[32]:[27.0.0.15]
Paths: (1 available, best #1)
Advertised to non peer-group peers:
TORC11(downlink-1) TORC12(downlink-2) TORC21(downlink-3) TORC22(downlink-4) TORS1(downlink-5) TORS2(downlink-6)
Route [3]:[0]:[32]:[27.0.0.15]
5550
27.0.0.15 from TORS1(downlink-5) (27.0.0.15)
Origin IGP, valid, external, bestpath-from-AS 5550, best
Extended Community: RT:5550:1003 ET:8
AddPath ID: RX 0, TX 227
Last update: Thu Feb 7 15:44:22 2019
PMSI Tunnel Type: Ingress Replication, label: 16777213 >>>>>>>
Displayed 1 prefixes (1 paths) with this RD (of requested type)
root@MSP1:~#
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
3. So VTEP2 didn't rx the correct label.
In an all FRR setup this doesn't have any functional consequence but some
vendors are validating the content of the label field as well and ignoring
the IMET route from FRR (say VTEP1 is FRR and VTEP2 is 3rd-party). The
functional consequence of this VTEP2 ignores VTEP1's IMET route and doesn't
add VTEP1 to the corresponding l2-vni flood list.
This commit fixes up the PMSI attr parsing on spine-1 -
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
root@MSP1:~# net show bgp l2vpn evpn route rd 27.0.0.15:4 type multicast
EVPN type-2 prefix: [2]:[ESI]:[EthTag]:[MAClen]:[MAC]
EVPN type-3 prefix: [3]:[EthTag]:[IPlen]:[OrigIP]
EVPN type-5 prefix: [5]:[ESI]:[EthTag]:[IPlen]:[IP]
BGP routing table entry for 27.0.0.15:4:[3]:[0]:[32]:[27.0.0.15]
Paths: (1 available, best #1)
Advertised to non peer-group peers:
TORC11(downlink-1) TORC12(downlink-2) TORC21(downlink-3) TORC22(downlink-4) TORS1(downlink-5) TORS2(downlink-6)
Route [3]:[0]:[32]:[27.0.0.15]
5550
27.0.0.15 from TORS1(downlink-5) (27.0.0.15)
Origin IGP, valid, external, bestpath-from-AS 5550, best
Extended Community: RT:5550:1003 ET:8
AddPath ID: RX 0, TX 278
Last update: Thu Feb 7 00:17:40 2019
PMSI Tunnel Type: Ingress Replication, label: 1003 >>>>>>>>>>>
Displayed 1 prefixes (1 paths) with this RD (of requested type)
root@MSP1:~#
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Ticket: CM-23790
Signed-off-by: Anuradha Karuppiah <anuradhak@cumulusnetworks.com>
Currently we are hardcoding it at the time of attr building to
ingress-replication. This is just a code clean-up and has no
functional impact.
Ticket: CM-23790
Signed-off-by: Anuradha Karuppiah <anuradhak@cumulusnetworks.com>
The `struct bgp_route_evpn` and `struct overlay_index` data
structures are exactly the same. Reduce to 1.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
community_free, lcommunity_free and ecommunity_free are similar type of functions. Most of the places, these three are called together. The signature of community_free is different from other two functions. Modified the community_free API signature to align with other two functions to avoid any confusion. There is no functionality impact with this and this is just to avoid any confusion.
Testing: manual testing and show commands
Signed-off-by: Sri Mohana Singamsetty msingamsetty@vmware.com
The ->hash_cmp and linked list ->cmp functions were sometimes
being used interchangeably and this really is not a good
thing. So let's modify the hash_cmp function pointer to return
a boolean and convert everything to use the new syntax.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
Add the ability to aggregate routes to handle
extended communities. Make the actions similiar
to what we do for normal communities.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
The peer->nexthop.ifp pointer must be set when parsing the
attributes in bgp_mp_reach_parse, notice this
and fail gracefully.
Rework bgp_nexthop_set to remove the HAVE_CUMULUS and to
fail the nexthop_set when we have a zebra connection and
no ifp pointer, as that not havinga zebra connection and
no ifp pointer is legal.
Signed-off-by: Donald Sharp <sharpd@cumulusnetworks.com>
EVPN ND ext community support NA flag R-bit, to have proxy ND.
Set R-bit in EVPN NA if a given router is default gateway or there is a
local
router attached, which can be determine based on local neighbor entry.
Implement BGP ext community attribute to generate and parse R-bit and
pass along zebra to program neigh entry in kernel.
Upon receiving MAC/IP update with community type 0x06 and sub_type 0x08,
pass the R-bit to zebra to program neigh entry.
Set NTF_ROUTER in neigh entry and inform kernel to do proxy NA for EVPN.
Ref:
https://tools.ietf.org/html/draft-ietf-bess-evpn-na-flags-01
Ticket:CM-21712, CM-21711
Reviewed By:
Testing Done:
Configure Local vni enabled L3 Gateway, which would act as router,
checked
show evpn arp-cache vni x ip <ip of svi> on originated and remote VTEPs.
"Router" flag is set.
Signed-off-by: Chirag Shah <chirag@cumulusnetworks.com>
