Description:
Change is intended for fixing the following issues related to vrf route leaking:
Routes with special nexthops i.e. blackhole/sink routes when imported,
are not programmed into the FIB and corresponding nexthop is set as 'inactive',
nexthop interface as 'unknown'.
While importing/leaking routes between VRFs, in case of special nexthop(ipv4/ipv6)
once bgp announces route(s) to zebra, nexthop type is incorrectly set as
NEXTHOP_TYPE_IPV6_IFINDEX/NEXTHOP_TYPE_IFINDEX
i.e. directly connected even though we are not able to resolve through an interface.
This leads to nexthop_active_check marking nexthop !NEXTHOP_FLAG_ACTIVE.
Unable to find the active nexthop(s), route is not programmed into the FIB.
Whenever BGP leaks routes, set the correct nexthop type, so that route gets resolved
and correctly programmed into the FIB, in the imported vrf.
Co-authored-by: Kantesh Mundaragi <kmundaragi@vmware.com>
Signed-off-by: Iqra Siddiqui <imujeebsiddi@vmware.com>
draft-ietf-bess-srv6-services-07 defines new SID structure Sub-Sub-TLV.
This patch adds SID structure information to bgp_attr_srv6_l3vpn. This
patch also defines default SID stucture used by following patches.
Signed-off-by: Ryoga Saito <contact@proelbtn.com>
This is to avoid breaking changes between existing deployments of
extended community for bandwidth encoding. By default FRR uses uint32
to encode bandwidth, which is not as the draft requires (IEEE floating-point).
This switch enables the required encoding per-peer.
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
When bgp receives the admin distance from a redistribution statement
let's store that distance for later usage.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
the realloc man page:
If ptr is NULL, then the call is equivalent to malloc(size)
This should be sufficient for our needs to not have to have
XMALLOC and XREALLOC
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
Process this a bit later instead of bgp_attr_parse() which is causing
the session to be shutdown upon receiving a prefix with AS number 0 inside.
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
This commit make bgpd to support VPN SID advertisement
as BGP Prefix-SID when route-leaking from BGP-vrf instance
to BGP-vpn instance.
Signed-off-by: Hiroki Shirokura <slank.dev@gmail.com>
This commit fix bgpd's prefix-sid type4,5 feature which has
miss implementation from https://github.com/FRRouting/frr/pull/5653
was merged. Due to some nessesary lines are not presented.
When bgpd receives multi update message with same service-sid on
prefix-sid type-5 attribute, bgpd will crash arround path-attribute's
values object reference count.
And also, this commit add a topotest to check that feature work fine.
Signed-off-by: Hiroki Shirokura <slank.dev@gmail.com>
Just for more debug information regarding malformed aggregator_as.
```
bgpd[5589]: [EC 33554434] 192.168.10.25: AGGREGATOR AS number is 0 for aspath: 65030
bgpd[5589]: bgp_attr_aggregator: attributes: nexthop 192.168.10.25, origin i, path 65030
```
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
Avoid mangling packet size which is expected to be the same as received.
Stream pointer advancing is necessary to avoid changing the packet and
reseting BGP sessions.
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
An UPDATE message that contains the AS number of zero in the AS_PATH
or AGGREGATOR attribute MUST be considered as malformed and be
handled by the procedures specified in [RFC7606].
An UPDATE message with a malformed AGGREGATOR attribute SHALL be
handled using the approach of "attribute discard".
Attribute discard: In this approach, the malformed attribute MUST
be discarded and the UPDATE message continues to be processed.
This approach MUST NOT be used except in the case of an attribute
that has no effect on route selection or installation.
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
The `struct ecommunity` structure is using an int for a size value.
Let's switch it over to a uint32_t for size values since a size
value for data can never be negative.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
Convert usage of the attr->evpn_overlay to get/set functionality.
Future commits will allow us to abstract this data to when
we actually need it for the `struct attr`.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
Abstract the access of `attr->cluster` to appropriate
accessor/set functionality.
Future commits will allow us to move this data around
to make `struct attr` smaller.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
Convert the `struct attr`->ipv6_ecommunity to use
accessor functions. We'll be able to reduce memory
usage in the `struct bgp_attr` by doing this.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
Add an accessor for the bgp_attr.pmsi_tnl_type to allow
us to abstract where it is. Every attribute is paying
the price of this bit of data as part of `struct bgp_attr`
In the future we'll move it elsewhere.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
The route_map_object_t was being used to track what protocol we were
being called against. But each protocol was only ever calling itself.
So we had a variable that was only ever being passed in from route_map_apply
that had to be carried against and everyone was testing if that variable
was for their own stack.
Clean up this route_map_object_t from the entire system. We should
speed some stuff up. Yes I know not a bunch but this will add up.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
DF (Designated forwarder) election is used for picking a single
BUM-traffic forwarded per-ES. RFC7432 specifies a mechanism called
service carving for DF election. However that mechanism has many
disadvantages -
1. LBs poorly.
2. Doesn't allow for a controlled failover needed in upgrade
scenarios.
3. Not easy to hw accelerate.
To fix the poor performance of service carving alternate DF mechanisms
have been proposed via the following drafts -
draft-ietf-bess-evpn-df-election-framework
draft-ietf-bess-evpn-pref-df
This commit adds support for the pref-df election mechanism which
is used as the default. Other mechanisms including service-carving
may be added later.
In this mechanism one switch on an ES is elected as DF based on the
preference value; higher preference wins with IP address acting
as the tie-breaker (lower-IP wins if pref value is the same).
Sample output
=============
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
torm-11# sh bgp l2vpn evpn es 03:00:00:00:00:01:11:00:00:01
ESI: 03:00:00:00:00:01:11:00:00:01
Type: LR
RD: 27.0.0.15:6
Originator-IP: 27.0.0.15
Local ES DF preference: 100
VNI Count: 10
Remote VNI Count: 10
Inconsistent VNI VTEP Count: 0
Inconsistencies: -
VTEPs:
27.0.0.16 flags: EA df_alg: preference df_pref: 32767
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
torm-11# sh bgp l2vpn evpn route esi 03:00:00:00:00:01:11:00:00:01
*> [4]:[03:00:00:00:00:01:11:00:00:01]:[32]:[27.0.0.15]
27.0.0.15 32768 i
ET:8 ES-Import-Rt:00:00:00:00:01:11 DF: (alg: 2, pref: 100)
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Signed-off-by: Anuradha Karuppiah <anuradhak@cumulusnetworks.com>
Attribute may not be long enough to contain a localpref value, resulting
in an assert on stream size. Gracefully handle this case instead.
Signed-off-by: Quentin Young <qlyoung@nvidia.com>
Example configuration:
route-map SET_SR_POLICY permit 10
set sr-te color 1
!
router bgp 1
bgp router-id 1.1.1.1
neighbor 2.2.2.2 remote-as 1
neighbor 2.2.2.2 update-source lo
address-family ipv4 unicast
neighbor 2.2.2.2 next-hop-self
neighbor 2.2.2.2 route-map SET_SR_POLICY in
exit-address-family
!
!
Learned BGP routes from 2.2.2.2 are mapped to the SR-TE Policy
which is uniquely determined by the BGP nexthop (2.2.2.2 in this
case) and the SR-TE color in the route-map.
Co-authored-by: Renato Westphal <renato@opensourcerouting.org>
Co-authored-by: GalaxyGorilla <sascha@netdef.org>
Co-authored-by: Sebastien Merle <sebastien@netdef.org>
Signed-off-by: Sebastien Merle <sebastien@netdef.org>
rfc 5701 is supported. it is possible to configure in bgp vpn, a list of
route target with ipv6 external communities to import. it is to be noted
that this ipv6 external community has been developed only for matching a
bgp flowspec update with same ipv6 ext commmunity.
adding to this, draft-ietf-idr-flow-spec-v6-09 is implemented regarding
the redirect ipv6 option.
Practically, under bgp vpn, under ipv6 unicast, it is possible to
configure : [no] rt6 redirect import <IPV6>:<AS> values.
An incoming bgp update with fs ipv6 and that option matching a bgp vrf,
will be imported in that bgp vrf.
Signed-off-by: Philippe Guibert <philippe.guibert@6wind.com>
This would be handy for situations when a notification was sent, but it's
absolutely not clear who triggered that.
Just in case dumping all attributes under the debug mode would help finding
the _bad_ attribute.
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
A new proxy flag has been added to the already existing NA extended
community to allow proxy advertisment of a local host by a VTEP that is
yet to indpendently establish local reachability.
Reference: draft-rbickhart-evpn-ip-mac-proxy-adv
The extendend mac-mobility sequence number needs to be synced across
the ES peers. However we cannot let a ES-peer path win over a local
path on the same ES. To accomplish that some parameters such as the
MM seq number are bubbled up from the non-best path to the local path.
This mechanism is explained further in the path-selection patch.
Signed-off-by: Anuradha Karuppiah <anuradhak@cumulusnetworks.com>
Add ESI as an inline attribute field along with the other EVPN
attributes. This may be re-worked when the rest of the EVPN
attributes find a new home.
Some cleanup has been done to get rid of stale/unused references
to ESI. And also to consolidate duplicate definitions of ES ID
types.
Signed-off-by: Anuradha Karuppiah <anuradhak@cumulusnetworks.com>
Remove mid-string line breaks, cf. workflow doc:
.. [#tool_style_conflicts] For example, lines over 80 characters are allowed
for text strings to make it possible to search the code for them: please
see `Linux kernel style (breaking long lines and strings)
<https://www.kernel.org/doc/html/v4.10/process/coding-style.html#breaking-long-lines-and-strings>`_
and `Issue #1794 <https://github.com/FRRouting/frr/issues/1794>`_.
Scripted commit, idempotent to running:
```
python3 tools/stringmangle.py --unwrap `git ls-files | egrep '\.[ch]$'`
```
Signed-off-by: David Lamparter <equinox@diac24.net>
This is not the attribute involved in path selection and by rfc7606 it should
be just ignored.
Signed-off-by: Donatas Abraitis <donatas.abraitis@gmail.com>
