Per the RFC6860, check OSPFv2 using point-to-multipoint
over Ethernet.
Enable the behavior of the RFC6860 using:
ip ospf prefix-suppress A.B.C.D
See:
https://www.rfc-editor.org/rfc/rfc6860#section-2.3.2.2
Note that nexthops are not required to assess the checks.
Signed-off-by: Vincent Jardin <vjardin@free.fr>
Getting this error:
2024-01-17 19:05:20,688 WARNING: torm11: Router(torm11): proc failed: rc 255 pid 2436134
args: /usr/bin/nsenter --mount=/proc/2435168/ns/mnt --net=/proc/2435168/ns/net --uts=/proc/2435168/ns/uts -F /bin/bash -c /sbin/bridge vlan add vid 1000 dev bridge
stdout: RTNETLINK answers: Operation not supported
stderr: *empty*
As I understand it the correct thing to do here is pass in:
bridge vlan add vid 1000 dev bridge self
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
When received malformed AS4 capability, it should return -1 (notification send),
and the received flag SHOULD NOT be set.
Signed-off-by: Donatas Abraitis <donatas@opensourcerouting.org>
mgmtd has to know if netns is used as the vrf backend to correctly
process interface names in northbound.
Signed-off-by: Igor Ryzhov <iryzhov@nfware.com>
RPKI FRR module should not send any RPKI error packet during the tests.
Exit rtrd when receiving error packet. Skip tests with errors if rtrd
has stopped.
Signed-off-by: Louis Scalbert <louis.scalbert@6wind.com>
If at least one of the candidate routes was received via EBGP, remove from
consideration all routes that were received via EBGP-OAD and IBGP.
Signed-off-by: Donatas Abraitis <donatas@opensourcerouting.org>
Tests can fail, let's be proactive and gather up a support
bundle when they fail. It will help diagnose the problem
to some extent.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
The OSPF TE topotest is using switches to interconnect router. During the test,
interfaces are shutdown on some routers to simulate link failure and check that
the TED is correctly updated. However, the switche between router avoid the
detection by the neighbor router that the interface is down i.e. the interface
line remains up as it is conneted to the switch and not to the router.
This patch update the tested topology by removing the switch and connect
directly the router excepted the inter AS link on R3. Interface are also
renamed accordingly.
Signed-off-by: Olivier Dugeon <olivier.dugeon@orange.com>
The test_ospf_suppres_fa.py script is using straight
up sleeps before testing that the next step worked properly.
On a unloaded test system this will work 100% of the time
on a loaded test system this will have random failures.
Convert the test to use run_and_expect and give each
section of the test 30 seconds to get to the next state
appropriately instead of 10.
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
Add a new topotest `srv6_encap_src_addr` which verifies that the
`source-address` command works properly.
Signed-off-by: Carmine Scarpitta <carmine.scarpitta@uniroma2.it>
