In order to set function length of SID freely, this PR relieves the
lower limitation of `func-bits`.
Signed-off-by: Ryoga Saito <ryoga.saito@linecorp.com>
Add default SRv6 Function Length for usecases like SRv6 L3VPN. The
default value (16) comes from the default Function length for SRv6
L3VPN in BGPd.
Signed-off-by: Ryoga Saito <ryoga.saito@linecorp.com>
There is a possibility that the same line can be matched as a command in
some node and its parent node. In this case, when reading the config,
this line is always executed as a command of the child node.
For example, with the following config:
```
router ospf
network 193.168.0.0/16 area 0
!
mpls ldp
discovery hello interval 111
!
```
Line `mpls ldp` is processed as command `mpls ldp-sync` inside the
`router ospf` node. This leads to a complete loss of `mpls ldp` node
configuration.
To eliminate this issue and all possible similar issues, let's print an
explicit "exit" at the end of every node config.
This commit also changes indentation for a couple of existing exit
commands so that all existing commands are on the same level as their
corresponding node-entering commands.
Fixes#9206.
Signed-off-by: Igor Ryzhov <iryzhov@nfware.com>
This commit is a part of #5853 works that add new clis to
configure SRv6 locator and its show commands.
Following clis are added on this commit.
vtysh -c 'conf te' \
-c 'segment-routing' \
-c ' srv6' \
-c ' locators' \
-c ' locator LOC1' \
-c ' prefix A::/64'
- "show segment-routing srv6 sid [json]"
- "show segment-routing srv6 locator [json]"
- "show segment-routing srv6 locator NAME detail [json]"
- "show runnning-config" (make it to print srv6 configuration)
Signed-off-by: Hiroki Shirokura <slank.dev@gmail.com>
This commit is a part of #5853 that add new cmd-node for SRv6 configuration.
This commit just add cmd-node and moving node cli only, acutual SRv6 config
command isn't added. (that is added later commit. of this branch)
new cli nodes:
* SRv6
* SRv6-locators
* SRv6-locator
Signed-off-by: Hiroki Shirokura <slank.dev@gmail.com>
