Convert bgp_prefix_sid2 to exabgp 4
Do not advertise prefixes to exabgp to avoid an issue where exabgp
resets the bgp session with the following notification:
> invalid ipv6 mpls-vpn next-hop length 48 expected 24 or 40
Signed-off-by: Louis Scalbert <louis.scalbert@6wind.com>
Create reate exabgp cli fifo even it is not used in topotests to avoid
this error message:
> 16:21:42 | 2290205 | cli | could not find the named pipes (exabgp.in and exabgp.out) required for the cli
> 16:21:42 | 2290205 | cli | we scanned the following folders (the number is your PID):
> 16:21:42 | 2290205 | cli control | - /run/exabgp/
> 16:21:42 | 2290205 | cli control | - /run/0/
> 16:21:42 | 2290205 | cli control | - /run/
> 16:21:42 | 2290205 | cli control | - /var/run/exabgp/
> 16:21:42 | 2290205 | cli control | - /var/run/0/
> 16:21:42 | 2290205 | cli control | - /var/run/
> 16:21:42 | 2290205 | cli control | - /usr/local/run/exabgp/
> 16:21:42 | 2290205 | cli control | - /usr/local/run/0/
> 16:21:42 | 2290205 | cli control | - /usr/local/run/
> 16:21:42 | 2290205 | cli control | - /usr/local/var/run/exabgp/
> 16:21:42 | 2290205 | cli control | - /usr/local/var/run/0/
> 16:21:42 | 2290205 | cli control | - /usr/local/var/run/
> 16:21:42 | 2290205 | cli control | please make them in one of the folder with the following commands:
> 16:21:42 | 2290205 | cli control | > mkfifo //run/exabgp.{in,out}
> 16:21:42 | 2290205 | cli control | > chmod 600 //run/exabgp.{in,out}
Signed-off-by: Louis Scalbert <louis.scalbert@6wind.com>
Log exabgp by default in /tmp/topotests/<testname>/<peername>/exabgp.log
Level is INFO.
Note that in case the configuration syntax is invalid, exabgp does not
log into the file and exits at startup. You can check a configuration
syntax by running:
> exabgp <exabgp.cfg>
Signed-off-by: Louis Scalbert <louis.scalbert@6wind.com>
Require exabgp >= 4.2.11 to allow to newer version to run exabgp
topotests. Next commits will adapt the exabgp topotests when needed.
Signed-off-by: Louis Scalbert <louis.scalbert@6wind.com>
The vrf name was not being displayed in this output.
New output:
eva# show bgp vrf all ipv4 uni summ
BGP router identifier 0.0.0.0, local AS number 99 VRF RED vrf-id 14
BGP table version 0
RIB entries 0, using 0 bytes of memory
Peers 1, using 20 KiB of memory
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd PfxSnt Desc
192.168.119.1 4 0 0 0 0 0 0 never Active 0 N/A
Total number of neighbors 1
BGP router identifier 0.0.0.0, local AS number 99 VRF GREEN vrf-id 15
BGP table version 0
RIB entries 0, using 0 bytes of memory
Peers 1, using 20 KiB of memory
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd PfxSnt Desc
192.168.119.1 4 0 0 0 0 0 0 never Active 0 N/A
Total number of neighbors 1
BGP router identifier 192.168.122.1, local AS number 99 VRF default vrf-id 0
BGP table version 0
RIB entries 0, using 0 bytes of memory
Peers 1, using 20 KiB of memory
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd PfxSnt Desc
192.168.119.1 4 0 0 0 0 0 0 never Active 0 N/A
Total number of neighbors 1
BGP router identifier 0.0.0.0, local AS number 99 VRF GrEEn vrf-id -1
BGP table version 0
RIB entries 0, using 0 bytes of memory
Peers 1, using 20 KiB of memory
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd PfxSnt Desc
192.168.119.1 4 0 0 0 0 0 0 never Idle 0 N/A
Total number of neighbors 1
eva#
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
Don't use 'interface WORD area A.B.C.D' for enabling OSPFv3 areas on
interfaces and instead use the standardized 'ipv6 ospf6 area A.B.C.D'.
Signed-off-by: Rafael Zalamena <rzalamena@opensourcerouting.org>
multi path support by snmp implies change in configuration and expected
tests results.
ipv6 trap test output is now ordered to avoid radom result due to
timeline.
Signed-off-by: Francois Dumontet <francois.dumontet@6wind.com>
Signed-off-by: Philippe Guibert <philippe.guibert@6wind.com>
1. When an OSPF interface is deleted, remove the references in link-local
LSA. Delete the LSA from the LSDB so that the callback has accessibily
to the interface prior to deletion.
2. Fix a double free for the opaque function table data structure.
3. Assure that the opaque per-type information and opaque function table
structures are removed at the same time since they have back pointers
to one another.
4. Add a topotest variation for the link-local opaque LSA crash.
Signed-off-by: Acee <aceelindem@gmail.com>
A route-map can be programmed to remove the route-target which
has been set with 'rt vpn export' command, but fails to remove
it.
Fix this by applying the route-map, then considering the resulting
extended community-list.
Add some tests to catch this issue.
Signed-off-by: Philippe Guibert <philippe.guibert@6wind.com>
Add a test to check that the presence of a route-map at
exportation with a 'set extcommunity rt' is enough to allow
the prefix to be exported.
Signed-off-by: Philippe Guibert <philippe.guibert@6wind.com>
Just to make sure we don't crash bgpd with double-free if an existing route
already exists.
Signed-off-by: Donatas Abraitis <donatas@opensourcerouting.org>
In the master branch a new MTYPE_SCRIPT_RES was created for
frrscript_get_results, lua_to decoders should use that
Signed-off-by: Donald Lee <dlqs@gmx.com>
