diff --git a/doc/user/ripd.rst b/doc/user/ripd.rst
index 5c60f4f4f1..67323e61f3 100644
--- a/doc/user/ripd.rst
+++ b/doc/user/ripd.rst
@@ -88,7 +88,7 @@ multipath routing.
 RIP Configuration
 =================
 
-.. clicmd:: router rip
+.. clicmd:: router rip [vrf NAME]
 
    The `router rip` command is necessary to enable RIP. To disable RIP, use the
    `no router rip` command. RIP must be enabled before carrying out any of the
@@ -149,13 +149,16 @@ RIP Configuration
 
    The default is to be passive on all interfaces.
 
-.. clicmd:: ip split-horizon
+.. clicmd:: ip split-horizon [poisoned-reverse]
 
 
    Control split-horizon on the interface. Default is `ip split-horizon`. If
    you don't perform split-horizon on the interface, please specify `no ip
    split-horizon`.
 
+   If `poisoned-reverse` is also set, the router sends the poisoned routes
+   with highest metric back to the sending router.
+
 .. _rip-version-control:
 
 RIP Version Control
@@ -174,8 +177,8 @@ discussion on the security implications of RIPv1 see :ref:`rip-authentication`.
 
 .. clicmd:: version VERSION
 
-   Set RIP version to accept for reads and send. ``VERSION`` can be either 1 or
-   1.
+   Set RIP version to accept for reads and send. VERSION can be either
+   ``1`` or ``2``.
 
    Disabling RIPv1 by specifying version 2 is STRONGLY encouraged,
    :ref:`rip-authentication`. This may become the default in a future release.
@@ -472,7 +475,7 @@ Show RIP Information
 
 To display RIP routes.
 
-.. clicmd:: show ip rip
+.. clicmd:: show ip rip [vrf NAME]
 
    Show RIP routes.
 
@@ -481,7 +484,7 @@ through RIP, this command will display the time the packet was sent and
 the tag information. This command will also display this information
 for routes redistributed into RIP.
 
-.. clicmd:: show ip rip status
+.. clicmd:: show ip rip [vrf NAME] status
 
    The command displays current RIP status. It includes RIP timer,
    filtering, version, RIP enabled interface and RIP peer information.
diff --git a/doc/user/ripngd.rst b/doc/user/ripngd.rst
index c7ca22bf95..df7a0e249e 100644
--- a/doc/user/ripngd.rst
+++ b/doc/user/ripngd.rst
@@ -22,14 +22,10 @@ ripngd Configuration
 
 Currently ripngd supports the following commands:
 
-.. clicmd:: router ripng
+.. clicmd:: router ripng [vrf NAME]
 
    Enable RIPng.
 
-.. clicmd:: flush_timer TIME
-
-   Set flush timer.
-
 .. clicmd:: network NETWORK
 
    Set RIPng enabled interface by NETWORK.
@@ -48,7 +44,7 @@ Currently ripngd supports the following commands:
 ripngd Terminal Mode Commands
 =============================
 
-.. clicmd:: show ip ripng
+.. clicmd:: show ipv6 ripng [vrf NAME] status
 
 .. clicmd:: show debugging ripng