fwupd/plugins/elantp

Elan TouchPad

Introduction

This plugin allows updating Touchpad devices from Elan. Devices are enumerated using HID and raw I²C nodes. The I²C mode is used for firmware recovery.

Firmware Format

The daemon will decompress the cabinet archive and extract a firmware blob in an unspecified binary file format.

This plugin supports the following protocol ID:

• tw.com.emc.elantp

GUID Generation

These device uses the standard DeviceInstanceId values, e.g.

• HIDRAW\VEN_04F3&DEV_3010

Additionally another instance ID is added which corresponds to the module ID:

• HIDRAW\VEN_04F3&DEV_3010&MOD_1234

These devices also use custom GUID values for the IC configuration, e.g.

• ELANTP\ICTYPE_09

Additionally another instance ID is added which corresponds to the IC type & module ID:

• ELANTP\ICTYPE_09&MOD_1234

Update Behavior

The device usually presents in HID mode, and the firmware is written to the device by switching to a IAP mode where the touchpad is nonfunctional. Once complete the device is reset to get out of IAP mode and to load the new firmware version.

On flash failure the device is nonfunctional, but is recoverable by writing to the i2c device. This is typically much slower than updating the device using HID and also requires a model-specific HWID quirk to match.

Vendor ID Security

The vendor ID is set from the HID vendor, for example set to HIDRAW:0x17EF

Quirk Use

This plugin uses the following plugin-specific quirks:

ElantpIcPageCount

The IC page count.

Since: 1.4.6

ElantpIapPassword

The IAP password.

Since: 1.4.6

External Interface Access

This plugin requires ioctl access to HIDIOCSFEATURE and HIDIOCGFEATURE.