proxmox-mirrors/fwupd
1
0
Fork 0
mirror of https://git.proxmox.com/git/fwupd synced 2025-05-24 11:12:49 +00:00
Code Issues Actions Packages Projects Releases Wiki Activity
2db7528b13
fwupd/plugins/altos
History
Richard Hughes 024cc230ed Add fu_device_set_progress_full() 
This allows the plugin to use the raw byte values as a progress counter without
first converting to a percentage.
2017-12-08 09:36:57 +00:00
..
data Add support for flashing the ChaosKey 2017-01-09 12:21:35 +00:00
fu-altos-device.c Add fu_device_set_progress_full() 2017-12-08 09:36:57 +00:00
fu-altos-device.h Set the progress and state on the FuDevice, not the FuPlugin 2017-11-30 20:51:52 +00:00
fu-altos-firmware.c Remove the ELF support from libdfu and move the code to the altos plugin 2017-09-07 18:39:23 +01:00
fu-altos-firmware.h Remove the ELF support from libdfu and move the code to the altos plugin 2017-09-07 18:39:23 +01:00
fu-altos-tool.c Set the progress and state on the FuDevice, not the FuPlugin 2017-11-30 20:51:52 +00:00
fu-plugin-altos.c Set the progress and state on the FuDevice, not the FuPlugin 2017-11-30 20:51:52 +00:00
meson.build altos: Rename FuDeviceAltos to FuAltosDevice 2017-11-13 13:58:37 +00:00
README.md Add support for flashing the ChaosKey 2017-01-09 12:21:35 +00:00

README.md

Altos Support

Introduction

Altos is a 8051 operating system for Altus-Metrum projects. The ChaosKey is a hardware random number generator that attaches via USB.

When the ChaosKey when inserted it appears as a device handled by the kernel with VID 0x1d50 and PID 0x60c6. If pins 1 and 5 are shorted as the device is connected then the bootloader is run, which presents VID 0xfffe and PID 0x000a.

The bootloader communication is not handled in the kernel, and a tty device is created so userspace can communicate with the hardware. Commands the bootloader accept are as follows:

List Information

Command: l\n Several lines of text about the device are transferred to the host, e.g.

altos-loader
manufacturer     altusmetrum.org
product          AltosFlash
flash-range      08001000 08008000
software-version 1.6.8

There doesn't appear to be any kind of end-of-message signal.

Read Flash

Command: R $addr\n where $addr is a memory address 0x8001000->0x8008000. 256 bytes of raw data are then transferred to the host.

Write Flash

Command: W $addr\n where $addr is a memory address 0x8001000->0x8008000. 256 bytes of raw data are then transferred to the device.

Application Mode

Command: v\n The device will reboot into application mode. This is typically performed after flashing firmware completes successfully.