# shim, a first-stage UEFI bootloader

shim is a trivial EFI application that, when run, attempts to open and
execute another application. It will initially attempt to do this via the
standard EFI `LoadImage()` and `StartImage()` calls. If these fail (because Secure
Boot is enabled and the binary is not signed with an appropriate key, for
instance) it will then validate the binary against a built-in certificate. If
this succeeds and if the binary or signing key are not forbidden then shim
will relocate and execute the binary.

shim will also install a protocol which permits the second-stage bootloader
to perform similar binary validation. This protocol has a GUID as described
in the shim.h header file and provides a single entry point. On 64-bit systems
this entry point expects to be called with SysV ABI rather than MSABI, so calls
to it should not be wrapped.

On systems with a TPM chip enabled and supported by the system firmware,
shim will extend various PCRs with the digests of the targets it is
loading.  A full list is in the file [README.tpm](README.tpm) .

To use shim, simply place a DER-encoded public certificate in a file such as
pub.cer and build with `make VENDOR_CERT_FILE=pub.cer`.

There are a couple of build options, and a couple of ways to customize the
build, described in [BUILDING](BUILDING).

See the [test plan](testplan.txt), and file a ticket if anything fails!