Pixman supports negative strides, but up until now they haven't been
tested outside of stress-test. This commit adds testing of negative
strides to blitters-test, scaling-test, affine-test, rotate-test, and
composite-traps-test.
The affine-test, blitters-test, and scaling-test all have the ability
to print out the bytes of the destination image. Share this code by
moving it to utils.c.
At the same time make the code work correctly with negative strides.
pixman_composite_trapezoids() is supposed to composite across the
entire destination, but it actually only composites across the extent
of the trapezoids. For operators such as ADD or OVER this doesn't
matter since a zero source has no effect on the destination. But for
operators such as SRC or IN, it does matter.
So for such operators where a zero source has an effect, don't clip to
the trap extents.
Cairo 1.10 will sometimes generate trapezoids like this, so we can't
consider them invalid. Fixes bug 45009, reported by Michael Biebl.
This reverts commit 2437ae80e5.
When a trapezoid has a top/bottom that is above/below the left/right
edges, degenerate trapezoids become possible. For example the edge
could be very short and close to horizontal. If the bottom edge is far
below the bottom point of such a short edge, the result is that the
lower right corner of the trapezoid will be extremely far to the left.
This kind of trapezoid causes overflows in the rasterization code, so
change pixman_trapezoid_valid() to reject them.
All the tests are linked to libutil, hence it makes sence to always
include utils.h and reuse what it provides (config.h inclusion, access
to private pixman APIs, ARRAY_LENGTH, ...).
Previously, this function would do coordinate calculations in such a
way that (x_dst, y_dst) would only affect the alignment of the source
image, but not of the traps, which would always be considered to be in
absolute destination coordinates. This is unlike the
pixman_image_composite() function which also registers the mask to the
destination.
This patch makes it so that traps are also offset by (x_dst, y_dst).
Also add a comment explaining how this function is supposed to
operate, and update tri-test.c and composite-trap-test.c to deal with
the new semantics.
