If the firmware hadn't brought up HDMI for us, we need to do its
power-on reset sequence (reset HD and and clear its STANDBY bits,
reset HDMI, and leave the PHY disabled).
Signed-off-by: Eric Anholt <eric@anholt.net>
This supports 420 and 422 subsampling with 2 or 3 planes, tested with
modetest. It doesn't set up chroma subsampling position (which it
appears KMS doesn't deal with yet).
The LBM memory is overallocated in many cases, but apparently the docs
aren't quite correct and I'll probably need to look at the hardware
source to really figure it out.
Signed-off-by: Eric Anholt <eric@anholt.net>
This implements a simple policy for choosing scaling modes
(trapezoidal for decimation, PPF for magnification), and a single PPF
filter (Mitchell/Netravali's recommendation).
Signed-off-by: Eric Anholt <eric@anholt.net>
This is enough for fbcon and bringing up X using
xf86-video-modesetting. It doesn't support the 3D accelerator or
power management yet.
v2: Drop FB_HELPER select thanks to Archit's patches. Do manual init
ordering instead of using the .load hook. Structure registration
more like tegra's, but still using the typical "component" code.
Drop no-op hooks for atomic_begin and mode_fixup() now that
they're optional. Drop sentinel in Makefile. Fix minor style
nits I noticed on another reread.
v3: Use the new bcm2835 clk driver to manage pixel/HSM clocks instead
of having a fixed video mode. Use exynos-style component driver
matching instead of devicetree nodes to list the component driver
instances. Rename compatibility strings to say bcm2835, and
distinguish pv0/1/2. Clean up some h/vsync code, and add in
interlaced mode setup. Fix up probe/bind error paths. Use
bitops.h macros for vc4_regs.h
v4: Include i2c.h, allow building under COMPILE_TEST, drop msleep now
that other bugs have been fixed, add timeouts to cpu_relax()
loops, rename hpd-gpio to hpd-gpios.
Signed-off-by: Eric Anholt <eric@anholt.net>
Acked-by: Daniel Vetter <daniel.vetter@ffwll.ch>
