Many platforms were specifying the `aspeed,external-nodes` property
required by the AST2500 pinctrl. However, its been specified in the
pinctrl node directly in aspeed-g5.dtsi for quite a long time now.
Remove the unnecessary override from all relevant platform dts files.
Link: https://lore.kernel.org/r/20240802-dt-warnings-bmc-dts-cleanups-v1-5-1cb1378e5fcd@codeconstruct.com.au
Signed-off-by: Andrew Jeffery <andrew@codeconstruct.com.au>
Signed-off-by: Joel Stanley <joel@jms.id.au>
Enable I2C bus 8 which is exposed on the IPMB_1 connector on the X570D4U
mainboard.
Additionally adds a descriptive comment to I2C busses 1 and 5.
Signed-off-by: Renze Nicolai <renze@rnplus.nl>
Signed-off-by: Andrew Jeffery <andrew@codeconstruct.com.au>
Restructure GPIO table to fit maximum line length.
Fix mistakes found while working on OpenBMC userland configuration and
based on probing the board.
Schematic for this board is not available. Because of this the choice
was made to use a descriptive method for naming the GPIOs.
- Push-pull outputs start with output-*
- Open-drain outputs start with control-*
- LED outputs start with led-*
- Inputs start with input-*
- Button inputs start with button-*
- Active low signals end with *-n
Signed-off-by: Renze Nicolai <renze@rnplus.nl>
Signed-off-by: Andrew Jeffery <andrew@codeconstruct.com.au>
This is a relatively low-cost AST2500-based Amd Ryzen 5000 Series
micro-ATX board that we hope can provide a decent platform for OpenBMC
development.
This initial device-tree provides the necessary configuration for
basic BMC functionality such as serial console, KVM support
and POST code snooping.
Signed-off-by: Renze Nicolai <renze@rnplus.nl>
Reviewed-by: Joel Stanley <joel@jms.id.au>
Link: https://lore.kernel.org/r/20231202003908.3635695-3-renze@rnplus.nl
Signed-off-by: Joel Stanley <joel@jms.id.au>
Signed-off-by: Andrew Jeffery <andrew@codeconstruct.com.au>
