mirror of
https://git.kernel.org/pub/scm/linux/kernel/git/chenhuacai/linux-loongson
synced 2025-09-01 15:14:52 +00:00
b74947b4f6
Currently, per-radio attributes are set on per-phy basis, i.e., all the radios present in a wiphy will take attributes values sent from user. But each radio in a wiphy can get different values from userspace based on its requirement. To extend support to set per-radio attributes, add support to get radio index from userspace. Add an NL attribute - NL80211_ATTR_WIPHY_RADIO_INDEX, to get user specified radio index for which attributes should be changed. Pass this to individual drivers, so that the drivers can use this radio index to change per-radio attributes when necessary. Currently, per-radio attributes identified are: NL80211_ATTR_WIPHY_TX_POWER_LEVEL NL80211_ATTR_WIPHY_ANTENNA_TX NL80211_ATTR_WIPHY_ANTENNA_RX NL80211_ATTR_WIPHY_RETRY_SHORT NL80211_ATTR_WIPHY_RETRY_LONG NL80211_ATTR_WIPHY_FRAG_THRESHOLD NL80211_ATTR_WIPHY_RTS_THRESHOLD NL80211_ATTR_WIPHY_COVERAGE_CLASS NL80211_ATTR_TXQ_LIMIT NL80211_ATTR_TXQ_MEMORY_LIMIT NL80211_ATTR_TXQ_QUANTUM By default, the radio index is set to -1. This means the attribute should be treated as a global configuration. If the user has not specified any index, then the radio index passed to individual drivers would be -1. This would indicate that the attribute applies to all radios in that wiphy. Signed-off-by: Roopni Devanathan <quic_rdevanat@quicinc.com> Link: https://patch.msgid.link/20250615082312.619639-2-quic_rdevanat@quicinc.com Signed-off-by: Johannes Berg <johannes.berg@intel.com> |
||
|---|---|---|
| .. | ||
| core.c | ||
| debugfs.c | ||
| dma.c | ||
| dma.h | ||
| eeprom.c | ||
| eeprom.h | ||
| init.c | ||
| initvals_phy.h | ||
| initvals.h | ||
| Kconfig | ||
| mac.c | ||
| mac.h | ||
| main.c | ||
| Makefile | ||
| mcu.c | ||
| mcu.h | ||
| mt7601u.h | ||
| phy.c | ||
| regs.h | ||
| trace.c | ||
| trace.h | ||
| tx.c | ||
| usb.c | ||
| usb.h | ||
| util.c | ||