Add support for the UART auxiliary devices. This enables access to up to
3 different UARTs, which are implemented in the FPGA.
Signed-off-by: Gerhard Engleder <eg@keba.com>
Link: https://lore.kernel.org/r/20241011191257.19702-9-gerhard@engleder-embedded.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Add support for the SPI controller auxiliary device. This enables access
to the SPI flash of the FPGA and some other SPI devices.
The actual list of SPI devices is detected by reading some bits out of
the previously registered I2C EEPROM.
Signed-off-by: Gerhard Engleder <eg@keba.com>
Link: https://lore.kernel.org/r/20241011191257.19702-4-gerhard@engleder-embedded.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
The KEBA CP500 system FPGA is a PCIe device, which consists of multiple
IP cores. Every IP core has its own auxiliary driver. The cp500 driver
registers an auxiliary device for each device and the corresponding
drivers are loaded by the Linux driver infrastructure.
Currently 3 variants of this device exists. Every variant has its own
PCI device ID, which is used to determine the list of available IP
cores. In this first version only the auxiliary device for the I2C
controller is registered.
Besides the auxiliary device registration some other basic functions of
the FPGA are implemented; e.g, FPGA version sysfs file, keep FPGA
configuration on reset sysfs file, error message for errors on the
internal AXI bus of the FPGA.
Signed-off-by: Gerhard Engleder <eg@keba.com>
Link: https://lore.kernel.org/r/20240630194740.7137-2-gerhard@engleder-embedded.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
