Allocate segmented trace buffer if firmware advertises the capability in
IOCfacts.
Upon driver load, read the trace buffer size from driver page 1, calculate
the required segments for trace buffer, and allocate segmented buffers.
Each segment is 4096 bytes in size.
While posting driver diagnostic buffer to firmware, advertise that trace
buffer is segmented.
Signed-off-by: Sumit Saxena <sumit.saxena@broadcom.com>
Signed-off-by: Ranjan Kumar <ranjan.kumar@broadcom.com>
Link: https://lore.kernel.org/r/20250129100850.25430-3-ranjan.kumar@broadcom.com
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
To be able to debug controller problems it is beneficial to allocate and
configure system/host memory buffers which can be used to capture hardware
and firmware diagnostic information.
Add functions required to allocate and post firmware and hardware
diagnostic buffers to the controller and to set up automatic diagnostic
capture triggers.
Captures will be triggered under the following circumstances:
1. Firmware is in FAULT state.
2. Admin commands time out.
3. Controller reset caused due to I/O timeout
Reported-by: kernel test robot <lkp@intel.com>
Closes: https://lore.kernel.org/oe-kbuild-all/202405151758.7xrJz6rp-lkp@intel.com/
Co-developed-by: Sathya Prakash <sathya.prakash@broadcom.com>
Signed-off-by: Sathya Prakash <sathya.prakash@broadcom.com>
Signed-off-by: Ranjan Kumar <ranjan.kumar@broadcom.com>
Link: https://lore.kernel.org/r/20240626102646.14298-2-ranjan.kumar@broadcom.com
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
