Reset hardware state to prevent hardware stays at abnormal state during
setting channel. Besides, add preparation for MLO/DBCC before setting
channel, and reconfigure registers after that.
Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://msgid.link/20240215055741.14148-5-pkshih@realtek.com
Configure RF registers according to band, channel, bandwidth. Since this
chip will support MLO, it needs check the operating mode to decide paths
we are going to configure.
Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://msgid.link/20240215055741.14148-4-pkshih@realtek.com
Add a chip_ops for WiFi 7 chips to set additional RF configurations
including MLO and PLL settings.
Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://msgid.link/20240202030642.108385-12-pkshih@realtek.com
This function is to set TX/RX path. Especially for 1SS rate, it can select
to TX on one or two antenna. Before this operation, stop hardware to
prevent transmitting/receiving unexpected packets. After that, restore
settings and reset hardware to prevent it stays on abnormal state.
Signed-off-by: Ping-Ke Shih <pkshih@realtek.com>
Signed-off-by: Kalle Valo <kvalo@kernel.org>
Link: https://msgid.link/20240124033637.12330-4-pkshih@realtek.com
