This platform uses the same GPIO controller as Nomadik. It however has
its own pinconf & pinmux controller. EyeQ5 is the first platform to use
gpio-nomadik independently from pinctrl-nomadik.
Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com>
Acked-by: Gregory CLEMENT <gregory.clement@bootlin.com>
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>
Add the SoC I2C controller nodes to the platform devicetree. Use a
default bus frequency of 400kHz. They are AMBA devices that are matched
on PeriphID.
Set transfer timeout to 10ms instead of Linux's default of 200ms.
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Andi Shyti <andi.shyti@kernel.org>
Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com>
Acked-by: Gregory CLEMENT <gregory.clement@bootlin.com>
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>
Add the MMC/SDHCI controller found in the eyeQ5 SoC. It is based on the
cadence sd4hc controller and support modes up to HS400 enhanced strobe.
Signed-off-by: Benoît Monin <benoit.monin@bootlin.com>
Acked-by: Gregory CLEMENT <gregory.clement@bootlin.com>
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>
Add a new reserved-memory node, containing bootloader config with MAC
addresses for both ethernet instances of the SoC.
Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com>
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Link: https://lore.kernel.org/r/20241230143035.265518-8-srinivas.kandagatla@linaro.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Change the structure of the clock tree: rather than individual
devicetree nodes registering each fixed factor clock derived from OLB
PLLs, have the OLB node provide the necessary clocks.
Remove eyeq5-clocks.dtsi and move the three remaining "fixed-clock"s to
the main eyeq5.dtsi file.
Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com>
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>
The OLB ("Other Logic Block") is a system-controller region hosting
clock, reset and pin controllers. It contains registers such as I2C
speed mode that need to be accessible by other nodes.
Remove fixed-clocks previously used; replace references.
Add parent crystal clock, fixed at 30MHz.
Add pin nodes for all functions.
Add mobileye,eyeq5-olb compatible node, hosting clk, reset and pinctrl.
Add reset and pinctrl references to UART nodes.
Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com>
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>
Add a device tree include file for the Mobileye EyeQ5 SoC.
Based on the work of Slava Samsonov <stanislav.samsonov@intel.com>
Signed-off-by: Gregory CLEMENT <gregory.clement@bootlin.com>
Signed-off-by: Thomas Bogendoerfer <tsbogend@alpha.franken.de>
