According to the AT24 EEPROM bindings the compatible string should
contain first the actual manufacturer, and second the corresponding
atmel model.
Add the atmel compatible fallback accordingly.
Signed-off-by: Francesco Dolcini <francesco.dolcini@toradex.com>
Link: https://lore.kernel.org/r/20250408202655.6329-1-francesco@dolcini.it
Signed-off-by: Nishanth Menon <nm@ti.com>
Add a GPIO hog to release PCIe reset on the carrier board, this is
required to use M.2 or mPCIe cards.
Verdin AM62 does not have any PCIe interface, however the Verdin family
has PCIe and normally an M.2 or mPCIe slot is available in the carrier
board that can be used with cards that use only the USB interface toward
the host CPU, for example cellular network modem.
Signed-off-by: Francesco Dolcini <francesco.dolcini@toradex.com>
Link: https://lore.kernel.org/r/20240327182801.5997-3-francesco@dolcini.it
Signed-off-by: Nishanth Menon <nm@ti.com>
Enable UART2 for AM62 based SOM's Verdin carrier boards Dahlia,
Development and Yavia.
Earlier Verdin UART2 was reserved by R5 DM firmware which can be now
configured using boardcfg during U-boot compilation. In a default
config, no one writes to this UART.
Signed-off-by: Parth Pancholi <parth.pancholi@toradex.com>
Reviewed-by: Francesco Dolcini <francesco.dolcini@toradex.com>
Link: https://lore.kernel.org/r/20231121160436.1032364-1-parth105105@gmail.com
Signed-off-by: Nishanth Menon <nm@ti.com>
Add Verdin CAN_2 (TI AM62 MCU_MCAN0) and enable it on the Yavia,
Dahlia and Verdin Development board.
Signed-off-by: Hiago De Franco <hiago.franco@toradex.com>
Signed-off-by: Francesco Dolcini <francesco.dolcini@toradex.com>
Link: https://lore.kernel.org/r/20230802073635.11290-3-francesco@dolcini.it
Signed-off-by: Nishanth Menon <nm@ti.com>
