This commit adds the RTS signal, specifies the compatible Broadcom chip,
its clock source, interrupts, GPIOs for wakeup and shutdown, maximum speed,
pinctrl settings, and power supplies.
Signed-off-by: Muhammed Efe Cetin <efectn@protonmail.com>
Signed-off-by: Jacobe Zang <jacobe.zang@wesion.com>
Link: https://lore.kernel.org/r/20250424-edge-v1-1-314aad01d9ab@wesion.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Enabling the GPU power domain requires that the GPU regulator is
enabled. The regulator is enabled at boot time, but gets disabled
automatically when there are no users.
This means the system might run into a failure state hanging the
whole system for the following use cases:
* if the GPU driver is being probed late (e.g. build as a
module and firmware is not in initramfs), the regulator
might already have been disabled. In that case the power
domain is enabled before the regulator.
* unbinding the GPU driver will disable the PM domain and
the regulator. When the driver is bound again, the PM
domain will be enabled before the regulator and error
appears.
Avoid this by adding an explicit regulator dependency to the
power domain.
Tested-by: Heiko Stuebner <heiko@sntech.de>
Reported-by: Adrián Martínez Larumbe <adrian.larumbe@collabora.com>
Tested-by: Adrian Larumbe <adrian.larumbe@collabora.com> # On Rock 5B
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Link: https://lore.kernel.org/r/20250220-rk3588-gpu-pwr-domain-regulator-v6-8-a4f9c24e5b81@kernel.org
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
The preferred nodename for fixed-regulators has changed to
pattern: '^regulator(-[0-9]+v[0-9]+|-[0-9a-z-]+)?$'
Fix all Rockchip DT regulator nodenames.
Signed-off-by: Johan Jonker <jbx6244@gmail.com>
Link: https://lore.kernel.org/r/0ae40493-93e9-40cd-9ca9-990ae064f21a@gmail.com
[adapted rebased on top of a number of other changes and included
neu6a-wifi + wolfvision-pf5-io-expander overlays]
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Khadas Edge2 uses the PCI-e Ampak AP6275P 2T2R Wi-Fi 6 module. The
pcie@0 node can be used as Bridge1, so the wifi@0 node is used as a
device under the Bridge1.
Co-developed-by: Muhammed Efe Cetin <efectn@protonmail.com>
Signed-off-by: Muhammed Efe Cetin <efectn@protonmail.com>
Reviewed-by: Arend van Spriel <arend.vanspriel@broadcom.com>
Signed-off-by: Jacobe Zang <jacobe.zang@wesion.com>
Link: https://lore.kernel.org/r/20240910-dts-v14-1-82b39bd91257@wesion.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Khadas Edge 2 exposes IR receiver pins as same as TF card via EXTIO. The
IR receiver is connected to MCU and SoC.
The board also has 2 PWM RGB leds. One is controlled by MCU and the
other is controlled by SoC. This commit adds support for the led
controlled by SoC using pwm-leds.
Signed-off-by: Muhammed Efe Cetin <efectn@protonmail.com>
Link: https://lore.kernel.org/r/335629f57e593e20418a4a55a1e662505640cbde.1708381247.git.efectn@protonmail.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
The serial ports on rk3588 are named uart0 - uart9. Board schematics
also use these exact numbers and we want those names to also reflect
in the OS devices because everything else would just cause confusion.
To prevent each board repeating their list of serial aliases, move them
to the soc dtsi, as all previous Rockchip soc do already.
Signed-off-by: Heiko Stuebner <heiko.stuebner@cherry.de>
Reviewed-by: Dragan Simic <dsimic@manjaro.org>
Link: https://lore.kernel.org/r/20231205164842.556684-2-heiko@sntech.de
200MHz is the default rk3588 emmc max-frequency added in dtsi, so why
the board DT files are adding the same value explicitly?
Drop that unchanged property value.
Signed-off-by: Jagan Teki <jagan@edgeble.ai>
Link: https://lore.kernel.org/r/20230621064507.479891-1-jagan@edgeble.ai
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Edge2 is an ultraslim, credit-card sized ARM PC designed by Khadas.
In this patch, we will add basic device tree support for this board,
Only eMMC, UART are enabled, so it's capable of booting into
a basic linux system from eMMC via serial console.
Signed-off-by: Yixun Lan <dlan@gentoo.org>
Link: https://lore.kernel.org/r/20230315033441.32719-3-dlan@gentoo.org
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
