cd-gpios is used for sdcard detects for sdmmc.
Fixes: 791c154c39 ("arm64: dts: rockchip: Add support for rk3588 based board Cool Pi CM5 EVB")
Signed-off-by: Andy Yan <andyshrk@163.com>
Link: https://lore.kernel.org/r/20250524064223.5741-1-andyshrk@163.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Enabling the GPU power domain requires that the GPU regulator is
enabled. The regulator is enabled at boot time, but gets disabled
automatically when there are no users.
This means the system might run into a failure state hanging the
whole system for the following use cases:
* if the GPU driver is being probed late (e.g. build as a
module and firmware is not in initramfs), the regulator
might already have been disabled. In that case the power
domain is enabled before the regulator.
* unbinding the GPU driver will disable the PM domain and
the regulator. When the driver is bound again, the PM
domain will be enabled before the regulator and error
appears.
Avoid this by adding an explicit regulator dependency to the
power domain.
Tested-by: Heiko Stuebner <heiko@sntech.de>
Reported-by: Adrián Martínez Larumbe <adrian.larumbe@collabora.com>
Tested-by: Adrian Larumbe <adrian.larumbe@collabora.com> # On Rock 5B
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Link: https://lore.kernel.org/r/20250220-rk3588-gpu-pwr-domain-regulator-v6-8-a4f9c24e5b81@kernel.org
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
The preferred nodename for fixed-regulators has changed to
pattern: '^regulator(-[0-9]+v[0-9]+|-[0-9a-z-]+)?$'
Fix all Rockchip DT regulator nodenames.
Signed-off-by: Johan Jonker <jbx6244@gmail.com>
Link: https://lore.kernel.org/r/0ae40493-93e9-40cd-9ca9-990ae064f21a@gmail.com
[adapted rebased on top of a number of other changes and included
neu6a-wifi + wolfvision-pf5-io-expander overlays]
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
The updates this time are a bit smaller than most times, mainly because
it is not totally dominated by new Qualcomm hardware support. Instead,
we larger than average updates for Rockchips, NXP, Allwinner and TI.
The only two new SoCs this time are both from NXP and are minor variants
of already supported ones.
The updates for aspeed, amlogic and mediatek came a little late, so
I'm saving those for part 2 in a few days if everything turns out fine.
New machines this time contain:
- two Broadcom SoC based wireless routers from Asus
- Five allwinner based consumer devices for gaming, set-top-box and
eboot reader applications
- Three older phones based on Qualcomm chips, plus the more recent
Sony Xperia 1 V
- 14 industrial and embedded boards based on NXP i.MX6, i.MX8,
layerscape and s32g3 SoCs
- six rockchips boards including another handheld game console
and a few single-board computers
On top of these, we have the usual cleanups for dtc warnings and
updates to add more features to already merged machines.
-----BEGIN PGP SIGNATURE-----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=SnV4
-----END PGP SIGNATURE-----
Merge tag 'soc-dt-6.10' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc
Pull SoC devicetree updates from Arnd Bergmann:
"The updates this time are a bit smaller than most times, mainly
because it is not totally dominated by new Qualcomm hardware support.
Instead, we larger than average updates for Rockchips, NXP, Allwinner
and TI. The only two new SoCs this time are both from NXP and are
minor variants of already supported ones.
The updates for aspeed, amlogic and mediatek came a little late, so
I'm saving those for part 2 in a few days if everything turns out
fine.
New machines this time contain:
- two Broadcom SoC based wireless routers from Asus
- Five allwinner based consumer devices for gaming, set-top-box and
eboot reader applications
- Three older phones based on Qualcomm chips, plus the more recent
Sony Xperia 1 V
- 14 industrial and embedded boards based on NXP i.MX6, i.MX8,
layerscape and s32g3 SoCs
- six rockchips boards including another handheld game console and a
few single-board computers
On top of these, we have the usual cleanups for dtc warnings and
updates to add more features to already merged machines"
* tag 'soc-dt-6.10' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (612 commits)
arm64: dts: marvell: espressobin-ultra: fix Ethernet Switch unit address
arm64: dts: marvell: turris-mox: drop unneeded flash address/size-cells
arm64: dts: marvell: eDPU: drop redundant address/size-cells
arm64: dts: qcom: pm6150: correct USB VBUS regulator compatible
arm64: dts: rockchip: add rk3588 pcie and php IOMMUs
arm64: dts: rockchip: enable onboard spi flash for rock-3a
arm64: dts: rockchip: add USB-C support to rk3588s-orangepi-5
arm64: dts: rockchip: Enable GPU on Orange Pi 5
arm64: dts: rockchip: enable GPU on khadas-edge2
arm64: dts: rockchip: Add USB3 on Edgeble NCM6A-IO board
arm64: dts: rockchip: Support poweroff on Edgeble Neural Compute Module
arm64: dts: rockchip: Add Radxa ROCK 3C
dt-bindings: arm: rockchip: add Radxa ROCK 3C
arm64: dts: exynos: gs101: specify empty clocks for remaining pinctrl
arm64: dts: exynos: gs101: specify bus clock for pinctrl_hsi2
arm64: dts: exynos: gs101: specify bus clock for pinctrl_peric[01]
arm64: dts: exynos: gs101: specify bus clock for pinctrl (far) alive
arm64: dts: Add/fix /memory node unit-addresses
arm64: dts: qcom: qcs404: fix bluetooth device address
arm64: dts: qcom: sc8280xp-x13s: enable USB MP and fingerprint reader
...
gpio_pwrctrl2 gets duplicated by both rk806_dvs1_null and rk806_dvs2_null
gpio_pwrctrl1 is unset. This typo appears in multiple files. Let's fix them.
Note: I haven't had the chance to test them all because I don't own all
of these boards (obviously). Please test if it's needed.
Signed-off-by: Jing Luo <jing@jing.rocks>
Link: https://lore.kernel.org/r/20240420130355.639406-1-jing@jing.rocks
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
According to the hardware design, the i2c address of audio codec es8316
on Cool Pi CM5 is 0x10.
This fix the read/write error like bellow:
es8316 7-0011: ASoC: error at soc_component_write_no_lock on es8316.7-0011 for register: [0x0000000c] -6
es8316 7-0011: ASoC: error at soc_component_write_no_lock on es8316.7-0011 for register: [0x00000003] -6
es8316 7-0011: ASoC: error at soc_component_read_no_lock on es8316.7-0011 for register: [0x00000016] -6
es8316 7-0011: ASoC: error at soc_component_read_no_lock on es8316.7-0011 for register: [0x00000016] -6
Fixes: 791c154c39 ("arm64: dts: rockchip: Add support for rk3588 based board Cool Pi CM5 EVB")
Signed-off-by: Andy Yan <andyshrk@163.com>
Link: https://lore.kernel.org/r/20240324112833.2181961-1-andyshrk@163.com
[also adapted the node name to audio-codec@10]
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Follow others rk3588 based boards, and u-boot only use mmc0/1
as mmc boot targets, so aliase sdmmc as mmc1.
Fixes: 791c154c39 ("arm64: dts: rockchip: Add support for rk3588 based board Cool Pi CM5 EVB")
Signed-off-by: Andy Yan <andyshrk@163.com>
Reviewed-by: Dragan Simic <dsimic@manjaro.org>
Link: https://lore.kernel.org/r/20240201121106.1471301-2-andyshrk@163.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Cool Pi CM5 EVB works as a mother board connect with CM5.
CM5 Specification:
- Rockchip RK3588
- LPDDR4 2/4/8/16 GB
- TF scard slot
- eMMC 8/32/64/128 GB module
- Gigabit ethernet x 1 with PHY YT8531
- Gigabit ethernet x 1 drived by PCIE with YT6801S
CM5 EVB Specification:
- HDMI Type A out x 2
- HDMI Type D in x 1
- USB 2.0 Host x 2
- USB 3.0 OTG x 1
- USB 3.0 Host x 1
- PCIE M.2 E Key for Wireless connection
- PCIE M.2 M Key for NVME connection
- 40 pin header
Signed-off-by: Andy Yan <andyshrk@163.com>
Link: https://lore.kernel.org/r/20231212124407.1897604-1-andyshrk@163.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
