ArmSoM Sige7 has onboard AP6275P Wi-Fi6 (PCIe) and BT5 (UART) module
which is similar with Khadas Edge2. This commit enables bluetooth
at uart6.
Signed-off-by: Jianfeng Liu <liujianfeng1994@gmail.com>
Link: https://lore.kernel.org/r/20250621135319.61766-1-liujianfeng1994@gmail.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
ArmSoM Sige7 uses the PCI-e AP6275P Wi-Fi 6 module. The pcie@0 node can
be used as Bridge1, so the wifi@0 node is used as a device under the
bridge 1 similar with Khadas Edge 2.
Signed-off-by: Jianfeng Liu <liujianfeng1994@gmail.com>
Link: https://lore.kernel.org/r/20250311142825.2727171-1-liujianfeng1994@gmail.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Enabling the GPU power domain requires that the GPU regulator is
enabled. The regulator is enabled at boot time, but gets disabled
automatically when there are no users.
This means the system might run into a failure state hanging the
whole system for the following use cases:
* if the GPU driver is being probed late (e.g. build as a
module and firmware is not in initramfs), the regulator
might already have been disabled. In that case the power
domain is enabled before the regulator.
* unbinding the GPU driver will disable the PM domain and
the regulator. When the driver is bound again, the PM
domain will be enabled before the regulator and error
appears.
Avoid this by adding an explicit regulator dependency to the
power domain.
Tested-by: Heiko Stuebner <heiko@sntech.de>
Reported-by: Adrián Martínez Larumbe <adrian.larumbe@collabora.com>
Tested-by: Adrian Larumbe <adrian.larumbe@collabora.com> # On Rock 5B
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Link: https://lore.kernel.org/r/20250220-rk3588-gpu-pwr-domain-regulator-v6-8-a4f9c24e5b81@kernel.org
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
The hdptxphy is a combo transmit-PHY for HDMI2.1 TMDS Link, FRL Link, DP
and eDP Link. Therefore, it is better to name it hdptxphy0 other than
hdptxphy_hdmi0, which will be referenced by both hdmi0 and edp0 nodes.
Signed-off-by: Damon Ding <damon.ding@rock-chips.com>
Link: https://lore.kernel.org/r/20250206030330.680424-3-damon.ding@rock-chips.com
[added armsom-sige7, where hdmi-support was added recently and also
the hdptxphy0-as-dclk source I just added]
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
The preferred nodename for fixed-regulators has changed to
pattern: '^regulator(-[0-9]+v[0-9]+|-[0-9a-z-]+)?$'
Fix all Rockchip DT regulator nodenames.
Signed-off-by: Johan Jonker <jbx6244@gmail.com>
Link: https://lore.kernel.org/r/0ae40493-93e9-40cd-9ca9-990ae064f21a@gmail.com
[adapted rebased on top of a number of other changes and included
neu6a-wifi + wolfvision-pf5-io-expander overlays]
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
This enables the on-chip thermal monitoring sensor (TSADC) on all
RK3588(s) boards that don't have it enabled yet. It provides temperature
monitoring for the SoC and emergency thermal shutdowns, and is thus
important to have in place before CPU DVFS is enabled, as high CPU
operating performance points can overheat the chip quickly in the
absence of thermal management.
Signed-off-by: Alexey Charkov <alchark@gmail.com>
Link: https://lore.kernel.org/r/20240617-rk-dts-additions-v5-2-c1f5f3267f1e@gmail.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
