The Qualcomm UFS phy switched from dedicated driver to QMP phy driver.
Eventually the old driver was removed in commit 02dca8c981 ("phy:
qcom: remove ufs qmp phy driver"). The original driver and its binding
used vddp-ref-clk regulator supply, but the new one did not and left the
supply unused.
The Qualcomm UFS phy bindings were also migrated to newer ones and
dropped support for vddp-ref-clk regulator in commit dc5cb63592
("dt-bindings: phy: migrate QMP UFS PHY bindings to
qcom,sc8280xp-qmp-ufs-phy.yaml").
It turns out that this regulator, although with inaccurate name
vddp-ref-clk, is actually needed to provide supply for VDD_PX10 (or
similar, depending on the SoC) used by UFS controller.
Bring back handling of this supply by using more appropriate regulator -
UFS controller host supply. This also fixes dtbs_check warning:
msm8998-oneplus-dumpling.dtb: phy@1da7000: 'vddp-ref-clk-supply' does not match any of the regexes: 'pinctrl-[0-9]+'
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Link: https://lore.kernel.org/r/20230905161920.252013-11-krzysztof.kozlowski@linaro.org
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
There is no need for the RRADC to be disabled by default,
lets just enable it by default and not clutter up DT.
Acked-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Signed-off-by: Caleb Connolly <caleb.connolly@linaro.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20230524-pmi8998-charger-dts-v2-1-2a5c77d2ff0c@linaro.org
Pin configuration property "input-enable" was used with the intention to
disable the output, but this is done by default by Linux drivers. Since
patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
input-enable") the property is not accepted anymore.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20230407175807.124394-3-krzysztof.kozlowski@linaro.org
The gpio node in PMIC dts'es define access to multiple GPIOs. Most Qcom
PMICs were already using the plural _gpios label to point to this node,
but a few PMICs were left behind including the recently-pulled
pm(i)8950.
Rename it from *_gpio to *_gpios for pm6125, pm6150(l), pm8005,
pm(i)8950, and pm(i)8998.
Signed-off-by: Marijn Suijten <marijn.suijten@somainline.org>
Acked-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20221209220450.1793421-1-marijn.suijten@somainline.org
DT schema expects TLMM pin configuration nodes to be named with
'-state' suffix and their optional children with '-pins' suffix.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20221013210612.95994-3-krzysztof.kozlowski@linaro.org
DT schema expects PMIC GPIO pin configuration nodes to be named with
'-state' suffix. Optional children should be either 'pinconf' or
followed with '-pins' suffix. This fixes dtbs_check warnings like:
sdm845-xiaomi-beryllium.dtb: gpios@c000: 'vol-up-active' does not match any of the regexes: '-state$', 'pinctrl-[0-9]+'
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20220507194913.261121-6-krzysztof.kozlowski@linaro.org
The OnePlus 5/5T both have an NXP PN553 which is supported by the
nxp-nci-i2c driver in mainline. It detects/reads NFC tags using
"nfctool" and with the NearD test scripts data can also be written
to be received by another device.
Signed-off-by: Jami Kettunen <jami.kettunen@somainline.org>
Reviewed-by: Caleb Connolly <caleb@connolly.tech>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20220225215642.3916-1-jami.kettunen@somainline.org
QUSB2 PHY requires vdd-supply for digital circuit operation. Add it for
platforms that miss it.
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
Acked-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20210928022002.26286-4-shawn.guo@linaro.org
The following properties are not supported and causing dtbs_check
warnings.
- vdda-phy-max-microamp
- vdda-pll-max-microamp
- vddp-ref-clk-max-microamp
- vddp-ref-clk-always-on
Drop them from QMP PHY nodes.
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20210929034253.24570-6-shawn.guo@linaro.org
Add device trees for OnePlus 5 (cheeseburger) and 5T (dumpling)
MSM8998 SoC smartphones with initial support included for:
- UFS internal storage
- USB peripheral mode
- Display
- Touch
- Bluetooth
- Hall effect sensor
- Power and volume buttons
- Capacitive keypad button backlight (on cheeseburger)
Signed-off-by: Jami Kettunen <jamipkettunen@gmail.com>
Link: https://lore.kernel.org/r/20210406010708.2376807-2-jamipkettunen@gmail.com
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
