Underscores should not be used in node names (dtc with W=2 warns about
them), so replace them with hyphens.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Douglas Anderson <dianders@chromium.org>
Link: https://lore.kernel.org/r/20240213145124.342514-1-krzysztof.kozlowski@linaro.org
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Pin configuration property "input-enable" was used with the intention to
disable the output, but this is done by default by Linux drivers. Since
patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
input-enable") the property is not accepted anymore.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20230407175807.124394-1-krzysztof.kozlowski@linaro.org
The PMIC regulators are not supposed to have unit addresses.
Fixes: e9783584c9 ("arm64: dts: qcom: msm8994-kitakami: Add VDD_GFX regulator")
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20230312183622.460488-6-krzysztof.kozlowski@linaro.org
DT schema expects TLMM pin configuration nodes to be named with
'-state' suffix and their optional children with '-pins' suffix.
Order the "function" and "pins" property to match other DTS.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20221018155450.39816-2-krzysztof.kozlowski@linaro.org
Use respective GPIO_ACTIVE_LOW/HIGH flags for tlmm GPIOs. Include
gpio.h header if this is first usage of that flag.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Signed-off-by: Bjorn Andersson <andersson@kernel.org>
Link: https://lore.kernel.org/r/20220802153947.44457-4-krzysztof.kozlowski@linaro.org
Remove regulator-always-on property where not necessary and mark regulators
that are not supposed to be voted active on boot with regulator-boot-on.
While at it, reorder the load properties to make it look more decent.
Reorder PMICs to fix a probe defer caused by messy dependencies and Linux's
inability to handle them (at least for now).
Signed-off-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20220319174645.340379-12-konrad.dybcio@somainline.org
This property doesn't seem to exist in the documentation nor
in source code, but for some reason it is defined in a bunch
of device trees.
Signed-off-by: Dang Huynh <danct12@riseup.net>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20211123162436.1507341-1-danct12@riseup.net
The qcom_rpm_smd_regulator driver uses vdd_lvs1_2-supply property to
specify the supply regulator for LVS1 and LVS2 (following the pin name
in the PMIC datasheet). Correct the board's device tree property, so
that the regulator supply is setup properly.
Cc: Konrad Dybcio <konrad.dybcio@somainline.org>
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20211104002949.2204727-4-dmitry.baryshkov@linaro.org
* Move 35500 clock-frequency to kitakami (turns out it's a Sony specific)
* Add missing interfaces
* Fix the naming scheme
* Fix up pin assignments to make all BLSPs work
* Add DMA where previously omitted
Signed-off-by: Gustave Monce <gustave.monce@outlook.com>
Co-developed-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Signed-off-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Link: https://lore.kernel.org/r/20210131013853.55810-3-konrad.dybcio@somainline.org
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
This patch adds support for the following Xperias:
* Z3+ [aka Z4 in some regions] (Ivy)
* Z4 Tablet (Karin)
* Z4 Tablet Wi-Fi (Karin_windy) [APQ8094]
* Z5 Compact (Suzuran)
* Z5 Premium (Satsuki)
These devices are very similar in terms of hardware, with main
differences being display panels.
While at it, update comments describing hardware used:
SMB charger seems to not be used after all, PMI8994 charger
is in use instead.
Signed-off-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Link: https://lore.kernel.org/r/20210118162432.107275-1-konrad.dybcio@somainline.org
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
There is an issue with Kitakami eMMCs dying when a quirk
isn't addressed. Until that happens, disable it.
Signed-off-by: Konrad Dybcio <konradybcio@gmail.com>
Link: https://lore.kernel.org/r/20200814154749.257837-1-konradybcio@gmail.com
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Add device tree support for the Sony Xperia Z5 smartphone.
It's based on Sony Kitakami platform (msm8994) and hence
a Kitakami-common DTSI has been created so as to reduce
clutter when remaining devices are added.
The board currently supports
* Serial
* SDHCI
* I2C
* Regulator configuration
* pstore log dump
* GPIO keys
Signed-off-by: Konrad Dybcio <konradybcio@gmail.com>
Link: https://lore.kernel.org/r/20200624150107.76234-9-konradybcio@gmail.com
[bjorn: Changed vendor identifier in board compatible from somc to sony]
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
