Unit addresses are expected to be lower case. Pointed also by W=1
builds:
Warning (simple_bus_reg): /soc/serial@5801A000: simple-bus unit address format error, expected "5801a000"
Link: https://lore.kernel.org/r/20230712074611.35952-1-krzysztof.kozlowski@linaro.org
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
This is to remove similar errors as below:
OF: /.../gpio-port@0: could not find phandle
Commit 7569486d79 ("gpio: dwapb: Add ngpios DT-property support")
explained the reason of above errors well and added the generic
"ngpios" property, let's use it.
Signed-off-by: Jisheng Zhang <Jisheng.Zhang@synaptics.com>
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Link: https://lore.kernel.org/r/20201210094056.54553-1-manivannan.sadhasivam@linaro.org'
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Earlier, the PWM registers were included as part of the pinctrl memory
map, but this turned to be useless as the muxing is being handled by the
SoC pin controller itself. Hence, this commit removes the pwm register
mapping from the pinctrl node to make it more clean.
Fixes: af2ff87de413 ("arm64: dts: bitmain: Add pinctrl support for BM1880 SoC")
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Add reset controller support for Bitmain BM1880 SoC. This commit also
adds reset support to UART peripherals.
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Reviewed-by: Philipp Zabel <p.zabel@pengutronix.de>
Add pinctrl support for Bitmain BM1880 SoC. This SoC only supports
pinmuxing and the pinctrl registers are part of the sctrl block.
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Add GPIO support for Bitmain BM1880 SoC based on Designware APB GPIO
controller IP. IP exposes 3 GPIO controllers with a total of 72 pins.
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Add devicetree support for Bitmain BM1880 SoC, consisting of a Dual
core ARM Cortex A53 subsystem, a Single core RISC-V subsystem and a Tensor
Processor subsystem. Only ARM Cortex A53 Application processor subsystem
support is enabled for now.
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Acked-by: Arnd Bergmann <arnd@arndb.de>
