All revisions of the PinePhone share most of the hardware.
This patch makes it easier to detect PinePhone hardware without
having to check for each possible revision.
Signed-off-by: Dylan Van Assche <me@dylanvanassche.be>
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
Link: https://lore.kernel.org/r/20201230104205.5592-1-me@dylanvanassche.be
The PinePhone has a Realtek rtl8723cs WiFi module.
On mainboard revisions 1.0 and 1.1, the reset input is always pulled
high, so no power sequence is needed. On mainboard revision 1.2, the
reset input is connected to PL2.
Signed-off-by: Ondrej Jirman <megous@megous.com>
Signed-off-by: Samuel Holland <samuel@sholland.org>
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
Link: https://lore.kernel.org/r/20201105054135.24860-6-samuel@sholland.org
All revisions of the PinePhone have an SGM3140 LED flash. The gpios were
swapped on v1.0 of the board, but this was fixed in later revisions.
Signed-off-by: Luca Weiss <luca@z3ntu.xyz>
Signed-off-by: Samuel Holland <samuel@sholland.org>
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
Link: https://lore.kernel.org/r/20201105054135.24860-4-samuel@sholland.org
Revision 1.2 should be the final production version of the PinePhone.
It has most of the known HW quirks fixed.
Interrupt to the magnetometer is routed correctly, in this revision.
The bulk of the changes are in how modem and the USB-C HDMI bridge
chip is powered and where the signals from the modem are connected.
Also backlight intensity seemingly behaves differently, than on the
1.1 and 1.0 boards, and the PWM duty cycle where backlight starts
to work is 10% (as tested on 2 1.2 PinePhones I have access to).
Signed-off-by: Ondrej Jirman <megous@megous.com>
Link: https://lore.kernel.org/r/20200703194842.111845-3-megous@megous.com
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
