The Liontron H-A133L board features an Ethernet controller with a
JLSemi JL1101 PHY. Its reset pin is tied to the PH12 GPIO.
Note that the reset pin must be handled as a bus-wide reset GPIO in
order to let the MDIO core properly reset it before trying to read
its identification registers. There's no other device on the MDIO bus.
The datasheet of the PHY mentions that the reset signal must be held
for 1 ms to take effect. Make it 2 ms (and the same for post-delay) to
be on the safe side without wasting too much time during boot.
Signed-off-by: Paul Kocialkowski <paulk@sys-base.io>
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
Tested-by: Andre Przywara <andre.przywara@arm.com>
Link: https://patch.msgid.link/20250707165155.581579-5-paulk@sys-base.io
Signed-off-by: Chen-Yu Tsai <wens@csie.org>
The H-A133L board is an industrial development board made by Liontron.
It contains a number of dedicated JST connectors, to connect external
peripherals. It features:
- Allwinner A133 SoC (4 * Arm Cortex-A53 cores at up to 1.6 GHz)
- 1 GiB, 2 GiB or 4 GiB of LPDDR4 DRAM
- between 16 and 128 GiB eMMC flash
- AXP707 PMIC (compatible to AXP803)
- 100 Mbit/s RJ45 Ethernet socket, using an JLSemi JL1101 PHY
- XR829 WIFI+Bluetooth chip
- 2 * USB 2.0 USB-A ports, plus three sets of USB pins on connectors
(connected via a USB hub connected to USB1 on the SoC)
- microSD card slot
- 3.5mm A/V port
- 12V power supply
- connectors for an LVDS or MIPI-DSI panel
Add the devicetree describing the board's peripherals and their
connections.
Despite being a devboard, the manufacturer does not publish a schematic
(I asked), so the PMIC rail assignments were bases on BSP dumps,
educated guesses and some experimentation. Dropping the always-on
property from any of the rails carrying it will make the board hang as
soon as the kernel turns off unused regulators.
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Link: https://patch.msgid.link/20250505164729.18175-4-andre.przywara@arm.com
[wens@csie.org: fix property in &usbphy; fix comment typo in &usb_otg]
Signed-off-by: Chen-Yu Tsai <wens@csie.org>
